Signal converter for electromagnetic flowmeters

2 PROFIBUS DPIFC 300Issued Signal converter Application program System integrationMth./yearHardware Firmware Hardware Software Driver Version Model name01/11 SignalconverterwithRS485interface +PA Profile3.0V3.0.2 / 100811SimaticPCS7other SPSof othermanufact.HW ConfigotherSoftware ofother SPSmanufact.GSDmanuf.specificGSDprofilespecificKR014500.GSD*KR024500.GSDPA039740.GSDIFC300(RS485)Rev.1IFC300(RS485)Rev.2Flow with 1AI,1TOT (PhyL 0)Laptop / PCPDM(≥ 6.0 SP3)DD(Ident.-No.)I3P*DD0300.03** -Pactware DTM ≥ GFP*DTM1.3.1FDT1.2-I3P*DTM1.0.7FDT1.2-*: If the GSD file "KR014500.GSD" is used, there will be supported only a limited amount offunctions by the software version (V1.2.0 / 060215 or V2.0.0 / 060112): I&M functions and fail safemode are not accessible. For full support of all profile specific or manufacturer specificfunctions/parameters use the GSD file "KR024500.GSD".GFP*: Generic Flow PROFIBUSI3P*: IFC300 PROFIBUS**: PDM 5.2 PDM 6.02.2 System configuration of PROFIBUS DP networkThe following diagram shows a typical network configuration with PROFIBUS devices with RS485interface in a non-hazardous environment. The PROFIBUS devices with RS485 interface do notneed any segment coupler. They are connected directly to the PROFIBUS DP network.Figure 2-1: PROFIBUS DP network1 SPS2 PROFIBUS DP with max. 12 Mbit/s3 Signal converter4 Other devices with PROFIBUS RS485 interface6www.krohne.com02/2011 - 4001086601 - AD IFC 300 PROFIBUS R01 en