SkyView - Dynon Avionics

SV-ADAHRS-20X Installation and Configuration3. Feed the nylon washer over the body of the probe.4. Hand-thread the nylon nut onto the threaded body of the probe. At this point, the nylonwasher should be sandwiched between the nylon nut and the inside of the fuselage.5. Carefully tighten the nut using the 9/16” wrench.6. Route and secure the probe wires to the location of the ADAHRS module. Keep wiresaway from radios, ignition, and other noisy electronics.7. Carefully insert the pins on the wires into the connector housing. Pins are not polarizedand lock into place when inserted correctly.8. Connect the probe to the ADAHRS module.If the OAT probe is installed correctly, there should be an outside air temperature reading onthe PFD.Adjusting OAT AdjustSkyView provides the ability to adjust the displayed OAT +/- 20F (11.1C). This adjustment isapplied across the OAT’s entire temperature range. This adjustment can be made under SETUPMENU >HARDWARE CALIBRATION > ADAHRS CALIBRATION > OAT OFFSET.PFD-Related SettingsOnce the physical ADAHRS installation is complete, it may be necessary to configure PFDrelatedADAHRS settings for the SkyView system. All ADAHRS settings are automatically sharedbetween displays in multi-display systems.Measurement UnitsSet altitude, distance and speed, temperature, barometer, and pressure measurement units asdetailed in the How to Configure Displayed Units Section of this guide.ADAHRS Source SelectionIf the installation has more than one ADAHRS, enter the ADAHRS Source Selection Page (SETUPMENU > PFD SETUP > ADAHRS SOURCE SELECTION) and specify the primary ADAHRS.In systems with more than one ADAHRS, the one noted as ACTIVE is the primary. All otherproperly functioning ADAHRS are noted as ONLINE.The SkyView system automatically switches to a backup ADAHRS in the case of afailure.Airspeed LimitationsUse the values on this page to set IAS tape colors. Set V-speed (e.g., stall speed in landingconfiguration) thresholds on the Airspeed Limitations Page (SETUP MENU > PFD SETUP >AIRSPEED LIMITATIONS). The values on this page are default values that act as placeholders.SkyView System Installation Guide - Revision J 5-7