SkyView - Dynon Avionics

Revision Revision Date DescriptionAdded firmware upgrade information for servos beingused from D10/D100 with older firmware.Clarified GPS serial connection wire functions and colors.Added SV-XPNDR-26X installation instructions andspecifications.Added SV-ARINC-429 installation instructions andspecifications.Added new requirement to connect TX and RX lines fromserial devices to ALL displays in parallel.Added information about Autopilot servos not needinglubrication.Clarified lack of boom mount AOA/Pitot mountavailability.F December 2010G March 2011Clarified that cable-side transponder TNC connector isnot provided by Dynon.Added SV-BAT-320 connection information for customersmaking their own harnesses.Added OAT connection information for customersmaking their own harnesses.Removed 30K resistor requirement for Rotax trigger coilRPM pickup.Clarified SV-GPS-250 connections when multiple displaysand/or SV-GPS-250 modules are involved.Added pinout table for Dynon Capacitance-to-VoltageConverter.Added connector labels to SkyView Network Module andDisplay Diagrams.Fixed orientation of SkyView connectors on diagrams.Clarified acceptable SV-ADAHRS-20X orientation.Added additional Garmin 430 and SL30 configurationinformation.Fixed link to AOA information on Dynon web site.Added LED status troubleshooting information forSkyView modules.SkyView System Installation Guide - Revision Jvii