SkyView - Dynon Avionics

SV-D700 / SV-D1000 Installation and ConfigurationBaud RateSet this to match the baud rate of the serial device that is connected to the serial port. SkyViewsupports the following baud rates: 1200, 2400, 4800, 9600, 19200, 38400, 57600, and 115200.Note that if you use a serial port for a split function (e.g., GPS in and altitude encoder out), theinput and output devices must use the same baud rate.Output DeviceSet output device to the data format the serial device should expect from the SkyView display(e.g., ICARUS (10ft)).Example SkyView Serial Port Configuration for Icarus-Compatible TransponderThis example assumes that an Icarus format compatible transponder has been installed onserial port 1.1. Enter the Serial Port 1 Setup Menu (SETUP MENU > LOCAL DISPLAY SETUP > SERIALPORT SETUP > SERIAL PORT 1 SETUP).2. Set serial 1 input device to NONE (SERIAL 1 IN DEVICE: NONE).3. Set serial 1 in function to NONE (SERIAL 1 IN FUNCTION: NONE).4. Set serial 1 baud rate to 9600 (SERIAL 1 IN/OUT BAUD RATE: 9600)5. Set serial 1 output device to ICARUS (100ft) or ICARUS (10ft) (SERIAL 1 OUT DEVICE:ICARUS (100ft) or ICARUS (10ft).6. Press BACK or EXIT to save the settings.Brightness SetupEnter the Brightness Setup Page (SETUP MENU > LOCAL DISPLAY SETUP > BRIGHTNESS SETUP)to characterize the display’s backlight behavior. The backlight level can be adjusted manually bythe user, automatically by the display based on ambient light conditions, or by an externalcontrol signal while on the Brightness Setup Page and in normal flight. Regardless of thespecified control method, users always have the option of manually adjusting the backlight levelin the Dim Menu.Manual Brightness ManagementTo set the backlight light level so that it is exclusively controlled manually (i.e., no automatic orexternal brightness control) set BRIGHTNESS SOURCE to MANUAL ONLY. In this mode, thebacklight level is managed exclusively by the user in all situations in the Dim Menu. Referencethe Basic Display Operation Procedures Section for instructions on how to manually adjust thebacklight level in the Dim Menu.Automatic Brightness ManagementTo set the backlight level so that it automatically adjusts, set BRIGHTNESS SOURCE to AUTO ORMANUAL. When this option is selected, dimming is normally controlled automatically viaambient light detection, but it can also be controlled manually by using the Dim Menu. Dynonhas created a default dimming profile that should work well in most aircraft. If you find that thisprofile does not work well in your installation, it can be customized to suit your preferences4-18 SkyView System Installation Guide - Revision J