SkyView - Dynon Avionics

More documents

Recommendations

Info

SV-D700 / SV-D1000 Installation and ConfigurationAudio output volume will be controlled via the interface on a SkyView display, so no externalcomponents are required.Discrete Input ConnectionsDiscrete input connections are currently not supported in SkyView. A future firmware updatewill enable this functionality. Do not connect anything to these pins at this time.Reserved Connections for Future UseDo not connect anything to unspecified DB37 connector pins (directly or using the displayharness). These are reserved for future use.Display SetupYou can access important information about a SkyView display as well as configure serial ports,characterize your display backlight behavior and specify other display-specific settings.How to Access Display Hardware InformationEnter the Display Hardware Information Page (SETUP MENU > LOCAL DISPLAY SETUP > DISPLAYHARDWARE INFORMATION) to access important display hardware information. This menucontains status information only—nothing on it is configurable. Reference the Status OperationSection of this guide for more information about this menu.Serial Port ConfigurationReference serial device documentation for serial communication specifications.SkyView serial ports are configured in the Serial Port Setup Menu (SETUP MENU > LOCALDISPLAY SETUP > SERIAL PORT SETUP). SkyView serial ports have four parameters that must bedefined:Input DeviceInput FunctionBaud RateOutput DeviceInput DeviceNote that sometimes a parameter will be defined as NONE on the screen. Forexample, when a serial port is configured as only an output, the input device andinput function will both be set to NONE.Set the input device to the data format the SkyView display should expect from an input device.The configurable options list contains equipment by brand and model and also generic dataformats such as NMEA and aviation. NMEA is the standard format for most GPS units (including4-16 SkyView System Installation Guide - Revision J
SV-D700 / SV-D1000 Installation and Configurationthe SV-GPS-250). Aviation is used by some Garmin and Bendix/King panel mount equipment. Ifyour specific equipment is listed by brand and model, we recommend you configure SkyView touse this option instead of a generic data format.If you have any ARINC-429 devices, these are configured separately. See the SV-ARINC-429Installation and Configuration Section of this guide for more information.Input FunctionSkyView has several options for input functions: NONE, GPS, NAV, or POS. Set the device’s inputfunction to NONE if it does not have an input function.GPS devices provide GPS position and navigational information. These devices aregenerally "moving maps" that depict airports, airspaces, etc, and can generate flightplans. They provide source data for the moving map, HSI, autopilot, synthetic vision, andthe clock in the Top Bar. An example GPS device is a Garmin X96.NAV devices provide radio-based navigational information from a VOR or ILS. Theyprovide source data for the HSI and autopilot. SkyView currently supports only theGarmin SL30 NAV Radio.POS devices provide only positional information. These are generally simple GPSreceivers which cannot do flight planning. They provide source data for the moving map,synthetic vision, and the clock in the Top Bar. Note that a POS device does not provideany data for the HSI and will not appear in the HSI NAVSRC rotation. An example POSdevice is the Dynon SV-GPS-250.Input Function Considerations and PrioritiesDynon’s Moving Map Page uses POS and GPS sources for its data. Regardless of the number ofdata sources in your system, this page prioritizes these sources and fails over to them asfollows:POS 1 GPS 1GPS 2GPS 3GPS 4POS 2POS 3POS 4For example, if your system has one SV-GPS-250 configured as POS 1 and a Garmin 396configured as GPS 1, the Moving Map will always use the SV-GPS-250 as its primary data source.If the SV-GPS-250 fails or you configure its input function to NONE, the Moving Map Page willuse the Garmin 396 (or other GPS source) configured as GPS 1 as its primary data source.The SkyView HSI uses GPS and NAV sources for its overlays and the user must choose thesource during operation.SkyView’s internal Navigation Mapping Software can generate navigationinformation which can be displayed on the HSI. The Navigation Mapping Softwarerequires GPS position information, which is sourced from the active (highestpriority in the above list) POS or GPS source. Regardless of what source is beingused for position information, the navigation provided by the Navigation MappingSoftware is always the GPS0 source on the HSI.SkyView System Installation Guide - Revision J 4-17
Page 3 and 4:
Contact InformationDynon Avionics,
Page 5 and 6:
Revision Revision Date DescriptionS
Page 7:
Revision Revision Date DescriptionA
Page 12 and 13: Table of ContentsEthernet Connectio
Page 14 and 15: Table of ContentsVP-X SkyView Displ
Page 16 and 17: IntroductionAbout this GuideIn the
Page 18 and 19: System PlanningTable 4 contains phy
Page 20 and 21: System PlanningSV-ADAHRS-200 and SV
Page 22 and 23: System PlanningThere are no module-
Page 24 and 25: System PlanningServos (SV32, SV42,
Page 26 and 27: System Planningon any one of them.
Page 28 and 29: System PlanningFigure 5-SkyView Sys
Page 30 and 31: System PlanningHSI RequirementsThe
Page 32 and 33: Basic SkyView Display OperationDisp
Page 34 and 35: Basic SkyView Display OperationA bu
Page 36: Basic SkyView Display OperationBasi
Page 41 and 42: Basic SkyView Display OperationGPS
Page 43: Basic SkyView Display OperationServ
Page 46 and 47: SV-D700 / SV-D1000 Installation and
Page 66 and 67: SV-ADAHRS-20X Installation and Conf
Page 73: SV-ADAHRS-20X Installation and Conf
Page 81 and 82: 7. SV-EMS-220 Installation and Conf
Page 83 and 84: SkyView Network ConnectionSV-EMS-22
Page 85 and 86: SV-EMS-220 Installation and Configu
Page 105 and 106: Tools and Equipment RequiredSV-EMS-
Page 109 and 110: Note that you may need access to th
Page 111 and 112:
Fuel Pressure SensorSV-EMS-220 Inst
Page 113 and 114:
SV-EMS-220 Installation and Configu
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
EMS Sensor Input MappingSV-EMS-220
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Example Contact Sensor SetupAssume
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
8. SV-GPS-250 Installation and Conf
Page 137 and 138:
SV-GPS-250 Installation and Configu
Page 139 and 140:
9. SV-BAT-320 InstallationThis chap
Page 141:
Battery Status CheckSV-BAT-320 Inst
Page 144 and 145:
Autopilot Servo Installation, Confi
Page 146 and 147:
Page 148 and 149:
Page 150 and 151:
Page 152 and 153:
Page 154 and 155:
Page 156 and 157:
Page 158 and 159:
Page 160 and 161:
Page 162 and 163:
Page 164 and 165:
Page 166 and 167:
Page 168 and 169:
Page 170 and 171:
Page 173 and 174:
11. SV-XPNDR-26X Installation, Conf
Page 175 and 176:
SV-XPNDR-26X Installation, Configur
Page 177 and 178:
Page 179 and 180:
Power/Ground InputSV-XPNDR-26X Inst
Page 181 and 182:
Serial GPS Position Input (Future U
Page 183 and 184:
Page 185 and 186:
Page 187 and 188:
Altitude Encoder CalibrationSV-XPND
Page 189 and 190:
12. SV-ARINC-429 Installation and C
Page 191 and 192:
SV-ARINC-429 Installation and Confi
Page 193 and 194:
ARINC Device ConnectionsSV-ARINC-42
Page 195 and 196:
Page 197:
Page 200 and 201:
Page 202 and 203:
Page 204 and 205:
Accessory Installation and Configur
Page 206 and 207:
Page 208 and 209:
Page 210 and 211:
Page 212 and 213:
Page 214 and 215:
Page 217 and 218:
15. Appendix A: Maintenance and Tro
Page 219 and 220:
Appendix A: Maintenance and Trouble
Page 221 and 222:
Display Input VoltageThe display's
Page 223 and 224:
Page 225:
Page 228 and 229:
Appendix B: SpecificationsSkyView C
Page 230 and 231:
Appendix B: SpecificationsSV-XPNDR-
Page 232 and 233:
Appendix C: Wiring and Electrical C
Page 234 and 235:
Page 236 and 237:
Page 238 and 239:
Page 240 and 241:
Page 242 and 243:
Page 244 and 245:
Page 246 and 247:
Page 249 and 250:
18. Appendix D: SV-EMS-220 Sensor I
Page 251 and 252:
19. Appendix E: Serial Data OutputA
Page 253 and 254:
` Appendix E: Serial Data OutputPar
Page 255 and 256:
` Appendix E: Serial Data OutputDYN
Page 257 and 258:
Page 259 and 260:
Page 261 and 262:
Page 263 and 264:
` Appendix E: Serial Data Output!11
show all

SkyView - Dynon Avionics

Create successful ePaper yourself

Delete template?

Save as template?