SkyView - Dynon Avionics

Revision Revision Date DescriptionInstallation and Configuration Chapter.Added an important note on page 5-7 regarding thenecessity of configuring airspeed limitations for autopilotservo calibration.Specified that the SV-EMS-220 warning light pin (DB37pin 29) should not be connected in Table 15.The SV-GPS-250 should now be configured as INPUTFUNCTION = POS 1.Clarified servo installation instructions regarding theconnection point on the servo arm with the linkagehardware on page 9-6.Updated the AP Disengage/CWS Button Section on page9-10 to say that the button is required instead of justhighly recommended.D June 2010E October 2010Document number changed to 101320-003.Added GPS Fix Status information.Added Fuel Flow pulses/gallon documentation.Clarified EMS GP input compatibility.Added information about obstacles and runways tosynthetic vision section.Added information about new autopilot pitch axissettings.Added information about optional External Alarm Lightconnection.Added information about fuel computer settings.Updated autopilot test procedures with additionalwarnings and precautions.Reiterated the importance of proper ADAHRS orientationand other installation requirements.Added note about servo self-lubrication.Clarified lack of specific boom-mount AOA/Pitotinstallation instructions.Added information about serial device and displayconnection requirements.viSkyView System Installation Guide - Revision J