SkyView - Dynon Avionics

SV-D700 / SV-D1000 Installation and Configuration3. Configure this serial port on each display under SETUP MENU > LOCAL DISPLAY SETUP >SERIAL PORT SETUP. The SERIAL IN device for this serial port should be set toICARUS/GARMIN ALTITUDE.Non-Dynon Transponder Serial Altitude Output InstallationTo use SkyView‘s altitude output functionality with your transponder that can receive serialaltitude input:1. Wire a SkyView serial transmit line to the respective receive connection on thetransponder. If you have multiple SkyView displays, a serial transmit wire from eachSkyView display should be connected to the external transponder in parallel.2. Ensure there is a shared ground between the D700/D1000 and the transponder.3. Configure the serial port on each display appropriately. There is an example serial portconfiguration on 4-18.Non-Dynon Transponder Serial Input InstallationSkyView can display the status of the Garmin GTX 327/330 transponders. To use thisfunctionality with SkyView:1. Wire a serial receive line to the respective transmit line on the transponder. If you havemultiple SkyView displays, the serial transmit wire from the external transponder shouldbe connected to a SkyView serial receive wire on each display in parallel.2. Ensure there is a shared ground between the D700/D1000 and the transponder.3. Configure the serial port on each display appropriately under SETUP MENU > LOCALDISPLAY SETUP > SERIAL PORT SETUP.4. Configure the serial port on the transponder appropriately. For a Garmin GTX 327/330,the RS-232 output of the appropriate serial port should be set to REMOTE+TIS.Gray-Code Transponder InstallationTo use SkyView’s altitude encoder functionality with your Gray Code transponder:1. Follow the installation instructions in the Encoder Serial-to-Gray Code ConverterInstallation and Configuration Section.2. Configure the serial port on each display according to the instructions on page 14-12.Reference the Serial Port Configuration Section of this guide for serial port configurationinformation.Garmin SL30If you are using a Garmin SL30 NAV/COM radio with SkyView:1. Connect SL30 serial RX pin 4 (RxD1) to one of the SkyView serial TX pins on each display.2. Connect SL30 serial TX pin 5 (TxD1) to one of the SkyView serial RX pins on each display.3. Configure the serial port on each display appropriately under SETUP MENU > LOCALDISPLAY SETUP > SERIAL PORT SETUP.4. Configure the serial port on the SL30 appropriately. On the SL30, the Indicator HeadType should be set to NONE.4-14 SkyView System Installation Guide - Revision J