SkyView - Dynon Avionics

SV-D700 / SV-D1000 Installation and ConfigurationSerial Port12345Wire FunctionTXRXTXRXTXRXTXRXTXRXSV-GPS-250PowerSV-GPS-250GroundTable 10 - SkyView Serial Port ConnectionsSkyView Display HarnessWire ColorsBrown with Orange stripeBrown with Violet stripeYellow with Orange stripeYellow with Violet stripeGreen with Orange stripeGreen with Violet stripeBlue with Orange stripeBlue with Violet stripeGray with Orange stripeGray with Violet stripeSolid OrangeSolid BlackTraffic DevicesSkyView has the ability to receive aircraft traffic information from different devices, includingthe SV-XPNDR-26X, the Zaon XRX, and the Garmin GTX 330 transponder. If a device that canprovide traffic is connected to SkyView and configured (usually as a serial traffic device underSETUP MENU > LOCAL DISPLAY SETUP > SERIAL PORT SETUP), further traffic display options canbe configured in SETUP MENU > TRAFFIC CONFIGURATION. The traffic display on both the PFDand MAP pages can be set to include just Traffic Advisories (TA), all targets, or no targets.Only one device can provide traffic information to SkyView at a time. If you haveboth the SV-XPNDR-26X and another traffic device installed, the non-Dynon devicewill receive priority and be used as the traffic source.SkyView Altitude Encoder Output FormatsThere must be a SkyView ADAHRS in the system for the altitude encoder output tofunction.SkyView outputs its altitude measurements in two different formats. You can use either formaton any of the serial ports. These formats are described in Table 11 and Table 12. SkyView willfunction properly whether or not this altitude encoder functionality is used.Used byBaud rate 9600ICARUSGarmin GTX330 (set on Icarus input), Garmin GTX327 (set on Icarusinput), Garmin GTX328, Icarus, Trimble4-12 SkyView System Installation Guide - Revision J