SkyView - Dynon Avionics

SV-D700 / SV-D1000 Installation and ConfigurationSee the Homemade Wire Harness Considerations section for importantspecifications that must be adhered to for the SV-BAT-320 to charge properlywhen used with a non-Dynon harness.SkyView Network ConnectorsThe two DB9 connectors on the back of a SkyView display are SkyView network connectors.They have identical pin-outs and are electrically connected inside the display (i.e., they arecompletely interchangeable). Installers may use either connector or both connectors in SkyViewinstallations. Reference Table 54 on page 17-8 for SkyView Network Connector pin-outinformation.Note that these connectors are not serial port connectors.Network Setup and StatusOnce all SkyView modules are connected in a network, either in a bench top test or permanentinstallation, turn the display(s) on. You will see the display boot up and the status LEDs on themodules light up.A tail number on the Aircraft Information Page (SETUP MENU > SYSTEM SETUP >AIRCRAFT INFORMATION) is required for network configuration.If you have more than one display in your SkyView system, the tail number onlyneeds to be set on the display that you initially perform the Network Configurationon. At network configuration time, all other displays that are set to the default tailnumber of DYNON will automatically have their settings and tail numbersynchronized with the display the configuration is performed from. Afterconfiguration, all displays’ tail numbers and settings will be synchronized, andfurther setup tasks can be performed from any display.Before you configure the SkyView network, the PFD and EMS pages will contain abig red “X” over a black screen. You must configure the network before PFD andEMS data is displayed on SkyViewUse the following procedure to configure a SkyView network:1. Navigate to the CONFIGURE… Page (SETUP MENU > SYSTEM SETUP > NETWORK SETUP> CONFIGURE…).2. Press DETECT. A successful network configuration yields the screen in Figure 17.3. Press FINISH to close the screen and return to the Network Setup Menu.4-8 SkyView System Installation Guide - Revision J