SkyView - Dynon Avionics

SV-D700 / SV-D1000 Installation and ConfigurationElectrical InstallationUse this section in conjunction with the information contained in Appendix C: Wiring andElectrical Connections (notably Figure 87 on page 17-7). The wires and wire colors in this sectionrefer to the wires on the included SkyView Display Harness (SV-HARNESS-D37).Power InputSkyView displays have a primary power input that is compatible with 12 volt and 24 voltsystems (10 to 30 volts DC). There are two unterminated solid red primary power input wires(to reduce current loading in each wire—these are not for redundancy and both should beconnected to the same power source) and two unterminated solid black primary ground wires.GroundingEnsure that there is an appropriately rated breaker or replaceable fuse on theprimary power input. A 5 amp breaker or replaceable fuse is sufficient for themajority of installations. Reference the Specifications Section of the SystemPlanning Chapter for more information.Ensure that all external devices that interface with SkyView have a common ground withSkyView. If a device does not share ground with SkyView, it may not communicate properly.Backup Battery Connection and Operation RulesSkyView displays have the option of an external backup battery (SV-BAT-320). The displayharness has a connector that mates with the connector on the backup battery. Simplyconnecting the display to the battery using this connector enables backup battery functionality.In the event of an electrical failure that causes SkyView to run on the SV-BAT-320, the SV-BAT-320 supplies power to the SkyView display it is connected to, along with any connected SV-ADAHRS-26X, SV-EMS-220, SV-ARINC-429, and SV-GPS-250 modules. Because of higher powerrequirements, the SV-BAT-320 does not power Autopilot servos, the SV-XPNDR-26X, or anyother external device.SkyView displays are only compatible with Dynon’s SV-BAT-320 battery pack. Donot connect a lead-acid battery or any other battery as the charging algorithm isoptimized for the SV-BAT-320. Connecting any other battery may have detrimentalconsequences. Damage caused by connecting such a battery will not be repairedunder warranty.In the event of primary power loss, a fully charged backup battery can keep mostSkyView systems operating for at least 60 minutes. The backup battery providespower for its connected display and that display’s attached SkyView modules. Itdoes not provide power for other displays or servos as they are not powered by adisplay.SkyView System Installation Guide - Revision J 4-7