SkyView - Dynon Avionics

SV-D700 / SV-D1000 Installation and ConfigurationPhysical InstallationSV-D700 Installation Dimension Quick Overview Panel Cutout: 6.97” x 5.35” Bezel Outline: 7.636” x 5.512”SV-D1000 Installation Dimension Quick Overview Panel Cutout: 9.68” x 6.90” Bezel Outline: 10.320” x 7.064”For those upgrading from a D100 series product, note that the SV-D700 display hasa slightly larger cutout than those products.Figure 13 and Figure 14 on the following pages show recommended panel cutouts andmounting hole patterns for SV-D700 and SV-D1000 displays. Note that the SkyView 7" displayhas a smaller cutout size and fewer mounting holes than the SkyView 10" display.Figure 15 and Figure 16 on the following pages show the mechanical dimensions of the SkyViewdisplays. Use the dimensions (in inches) found in the appropriate diagram to plan for the spacerequired by the display.To mount a SkyView display, cut an appropriately sized rectangular opening in your panel, drillout the mounting holes, and use the included mounting screws to fasten the display to thepanel.SkyView displays are shipped with #6-32 hex-drive round head fasteners. Fasteners are 5/8” inlength and require a 5/64” hex drive tool. Dynon recommends fastening the included mountingscrews to nut plates installed behind the panel. If access behind the panel allows, standard #6-32 lock nuts or nuts with lock washers can be used. Do not rivet the SkyView display to theaircraft as this will hinder future removal if necessary.4-2 SkyView System Installation Guide - Revision J