SkyView - Dynon Avionics

Basic SkyView Display OperationSensor Setup–Enter this menu to configure the graphical display properties of mappedsensors. Reference the EMS Sensor Setting Section of this guide for more informationregarding sensor setup.MAP Setup MenuThis menu contains links to the following wizards and menus:Max Zoom Levels–Use these settings to specify the largest zoom level that the variousfeatures are displayed.Information Items–Use these settings to place information items on the MAP page.Autopilot Setup MenuThis menu is not accessible until the autopilot servos in the system have beensuccessfully calibrated and tested. Reference the Autopilot Servo Calibration andTest Procedures Section of this guide for more information.This menu contains links to the following menus:Roll Axis–Enter this menu to configure autopilot roll axis parameters and options such astorque, sensitivity, mode, maximum bank angle, and turn rate target.Pitch Axis–Enter this menu to configure autopilot pitch axis parameters and optionssuch as torque, sensitivity, default climb vertical speed, default descent vertical speed,maximum airspeed, and minimum airspeed.Disengage Button–Enter this menu to configure disengage button options such as holdto engage, enable broken line detect, and control wheel steering mode.Transponder Setup MenuThis menu is not accessible unless a SV-XPNDR-26X is setup and configured.Reference the SV-XPNDR-26X Installation, Configuration, and Testing Section of thisguide for more information.This menu contains options that are used to set up and configure the SV-XPNDR-26X module.Reference the SV-XPNDR-26X Installation, Configuration, and Testing Section of this guide formore information.Hardware Calibration MenuThis menu contains links to the following menus:ADAHRS Calibration–Enter this menu to make altitude adjustments (e.g., baro andaltitude adjust) and access the compass and AOA calibration wizards.EMS Calibration–Enter this menu for EMS sensor calibration. You will have options tocalibrate fuel tanks and position potentiometers that have been mapped in the SensorInput Mapping Wizard. Calibration wizards contain onscreen instructions.3-12 SkyView System Installation Guide - Revision J