SkyView - Dynon Avionics

Menu NavigationBasic SkyView Display OperationAfter the display turns on, you will see a screen similar to the one in Figure 7. This guide refersto the label bar at the bottom of the screen as the Main Menu.Throughout this guide, the “>” character is used to indicate a sequence of menu selections orother actions you would take as you navigate the menu system. Menu selections which arefollowed by “…” indicate full-screen wizard interfaces which guide you through the appropriatesteps. These wizard interfaces are not described in detail in this guide, as the on-screeninstructions provide adequate information.SkyView menus follow this structure: SETUP MENU > MENU > ... > MENU > PAGE or WIZARD.The setup menus (In Flight Setup or Setup) are the root of most menu navigation. Each nestedmenu is more specific than the previous one and there is no set limit for the number of nestedmenus before reaching a page. A page or wizard is at the end of the chain and it is where theuser can perform a specific action such as create a system software backup, configure aSkyView network, or set up the layout of the onscreen engine gauges. Wizards employ easy-tofollowonscreen instructions.For example, SETUP MENU > SYSTEM SETUP > MEASUREMENT UNITS > BAROMETER indicatesentering the SETUP MENU, then selecting SYSTEM SETUP, then selecting MEASUREMENTUNITS, and then entering the BAROMETER Menu to select INHG, MBAR, or MMHG.Table 8 is a summary of menu navigation.Desired Menu ActionEnter the Setup MenuScroll through different menusEnter menuReturn to previous menuSave adjusted valueReset adjustable valueSave settings and return to Main MenuUser ActionSimultaneously press and hold buttons 7 and 8(if airspeed is greater than zero, you will enter theIn Flight Setup Menu)Turn either joystickORMove either joystick up or downMove either joystick toward the rightMove either joystick toward the left (saves settings)ORPress BACK (saves settings)ORPress CANCEL (does not save settings)Press ACCEPTPress DEFAULTPress EXITTable 8–Menu Navigation SummarySkyView System Installation Guide - Revision J 3-5