SkyView - Dynon Avionics

` Appendix E: Serial Data OutputParameterStartCharacterPositionNumCharsPinGP input 13 196 6 C37 P31Contacts 202 16Not UsedinSkyViewRange ofValues/UnitsVariessee note 3Example/NotesSee GP output table- ZZZZZZZZZZZZZZZZChecksum 218 2 - -3a (0x3a) 1 byte sum of all217 preceding bytes.CR/LF 220 2 - 0x0D,0x0A Carriage Return, LinefeedTable 63 – Dynon EMS Serial Output FormatNote 1: These sensors can be connected to various pins on the EMS 37-pin D-sub connector(DB37). See the SkyView Installation Guide for more information.Note 2: If the value is invalid, or out of range for the sensor, or the sensor is not configured, orif the sensor is configured but not calibrated, then an 'X' is output for each character in the fieldinstead of a valueNote 3: Units for each GP input depends on the type of sensor that is connected to the pin.See GP OutputsGP OutputsThe output for GP input pins is:ZZZZZZZ if a sensor has not been configured for the pinXXXXXX if a sensor is configured but the signal is out of range or invalid, or the sensorhas not been calibrated.+YYYYZ or –YYYYZ if the signal is valid where:o YYYY is the value of the signal in units defined in the GP Ouput Tableo Z is the units character from the GP Output TableSensor Type ( andName if applicable)Units Units Character Example/RangeTemperature °C*10 C +1234C (123.4 °C)Pressure PSI*10 P +1234P (123.4 PSI)Level Gallons*10 G +1234G (123.4 gal)Volts volts*1000 V +1234V (1.234 V)SkyView System Installation Guide - Revision J 19-11