SkyView - Dynon Avionics

Appendix A: Maintenance and TroubleshootingEnsure that the GPS serial port’s parameters are configured correctly. Go to the SerialPort Setup Menu (SETUP MENU > LOCAL DISPLAY SETUP > SERIAL PORT SETUP > SERIALPORT # SETUP) and check the input device, function, baud rate, and output deviceproperties of the port. This menu also contains serial transmit (TX) and receive (RX)counters. These show activity on the transmit and receive lines of that port and canindicate if the GPS is at least active on that port. Reference the SV-GPS-250 SerialConnection Section for SV-GPS-250 serial port settings. Also reference the Serial DevicesSection on page 4-10 of this guide if a comprehensive explanation of SkyView serialconnections is necessary.Engine Sensor Does Not Show Up OnscreenMake sure the sensor is installed, defined, mapped, and configured according to theinstructions found in the SV-EMS-220 Installation and Configuration Chapter.SkyView System Installation Guide - Revision J 15-9