SkyView - Dynon Avionics

Appendix A: Maintenance and Troubleshooting6. Assuming the Autopilot was previously set up and working correctly, you only need torecalibrate the servos by going to SETUP MENU > HARDWARE CALIBRATION > SERVOCALIBRATION > CALIBRATION and following the on-screen instructions.All other SkyView Network Components1. Reinstall the SkyView Network component in the aircraft.2. Reconnect all harnesses and connections as originally installed.3. Power up the SkyView System.4. From any display in the aircraft, reconfigure SkyView Network under SETUP MENU >NETWORK SETUP > CONFIGURE…5. No further action should be required.Status OperationSkyView displays give users access to vital operational information in the Display HardwareInformation Page (SETUP MENU > LOCAL DISPLAY SETUP > DISPLAY HARDWAREINFORMATION). Note that the information in this menu may be useful during troubleshooting.The information here cannot be edited on this screen; however, some parameters are editableby the user on other screens.This menu contains the following information:Display serial numberFirmware versionDisplay input voltageBackup battery charge stateOperational state of the internal battery management circuitryOperational state of the internal voltage railsScreen brightness levelLocal light sensor outputExternal light sensor outputBrightness level outputContact input statusSerial port status and current baud rateButton and joystick statesOperational hoursDisplay Serial NumberThe serial number of the display is noted here as SERIAL NUMBER: XXXXXX.Display Firmware VersionThe firmware version of the display is noted here as FIRMWARE VERSION: X.X.XX.XXX.15-4 SkyView System Installation Guide - Revision J