SkyView - Dynon Avionics

System PlanningThere are no module-to-module proximity requirements when installing multipleSV-ADAHRS-20X modules in an aircraft. For example, one SV-ADAHRS-20X may beinstalled on top of another SV-ADAHRS-20X module. Other installation locationrequirements still apply.The ADAHRS installation location should also adhere to the following requirements:Avoid locations that are lower than the lowest point in the pitot/static system to reducethe chance of allowing moisture to enter the module.Avoid locations that are subject to severe vibration.Avoid locations that are subject to rapid changes in temperature.Avoid locations that are subject to extreme humidity.Leave ample working room for electrical and pneumatic connections.SV-EMS-220Observe the following guidelines when choosing a location for an SV-EMS-220 Engine Monitormodule:Do not install on the engine side of the firewall.Avoid locations that are subject to severe vibration.Avoid locations that are subject to extreme humidity.Leave ample working room for electrical connections.SkyView systems support one SV-EMS-220 per network. Future updates may includesupport for more than one SV-EMS-220 for multiple engine support.SV-GPS-250Observe the following guidelines when choosing a location for an SV-GPS-250 GPS Receivermodule:Optimal mounting location is a rigid surface on top of the aircraft.Mounting location should be relatively level.Avoid antenna shadows (i.e., obstructions that block the antenna’s view of the sky).Do not locate the receiver within 3 feet of transmitting antennas.All four of the SV-GPS-250 module’s wires should all be connected to each SkyViewsystem display for redundancy.The SV-GPS-250 can be mounted inside the aircraft, however some signaldegradation will occur. If you are concerned with possible performance issues withthe intended installation location, verify GPS functionality at that location with atemporary installation. For optimal performance, the GPS receiver must have aclear view of the sky during maneuvers.2-6 SkyView System Installation Guide - Revision J