SkyView - Dynon Avionics

Appendix A: Maintenance and Troubleshooting10. Using a display that never left the aircraft (and is presumably configured and workingcorrectly):It is important that this step is done from the correct display. If networkconfiguration is done from the repaired unit, it is possible for it to overwrite thecorrect settings that are stored in your good display with the Dynon defaultfactory settings.a. Confirm that the tail number under SYSTEM SETUP > AICRAFT INFORMATION isset to the actual aircraft tail number, not DYNON.b. Reconfigure SkyView Network under SETUP MENU > NETWORK SETUP >CONFIGURE…c. Confirm all SkyView Network components are found, including ALL displays thatare in the aircraft.d. Exit Setup mode.11. On the recently repaired display, confirm that the tail number under SYSTEM SETUP >AICRAFT INFORMATION is now set to the actual aircraft tail number, not DYNON. Thisimplies that all settings and configurations have been synchronized from the otherdisplay.SV-ADAHRS-20X Modules1. Reinstall the ADAHRS in the aircraft.2. Reconnect all harnesses and connections as originally installed.3. Power up the SkyView System.4. From any display in the aircraft, reconfigure SkyView Network under SETUP MENU >NETWORK SETUP > CONFIGURE…5. Confirm all SkyView Network components are found, including the reinstalled ADAHRS.6. If the ADAHRS is the same serial number as the one you returned for repair, no furtheractions should be required. However, Dynon recommends double checking theperformance of magnetic heading and AOA calibration. If these do not seem to work aswell as they previously did, redo those calibrations.7. If the ADAHRS is not the same serial number as the one you returned for repair, allsetup and calibration steps in the SV-ADAHRS-20X Installation and Configuration sectionof the SkyView Installation manual should be performed as if the ADAHRS is beinginstalled for the first time.Autopilot Servos1. Reinstall the servo in the aircraft.2. Reconnect all harnesses and connections as originally installed.3. Power up the SkyView System.4. From any display in the aircraft, reconfigure SkyView Network under SETUP MENU >NETWORK SETUP > CONFIGURE…5. Confirm all SkyView Network components are found, including the reinstalled servo.SkyView System Installation Guide - Revision J 15-3