You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Appendix A: Maintenance and TroubleshootingReturning <strong>SkyView</strong> Components to Service after Repair<strong>SkyView</strong> Network enabled components such as modules, servos, and displays are shipped in a“like new” state after repair. To return a <strong>SkyView</strong> Network component to <strong>SkyView</strong> Network,follow the following directions:SV-D1000/D700 Display, when display is the ONLY display in the aircraft1. Reinstall the display into the panel.2. Reconnect all harnesses and connections as originally installed.3. Power up the <strong>SkyView</strong> System.4. If you have a settings backup on a USB memory stick:a. Load settings backup via SETUP MENU > SYSTEM SOFTWARE > LOAD FILES.b. Confirm that the tail number under SYSTEM SETUP > AICRAFT INFORMATION isset to the actual aircraft tail number, not DYNON.c. Reconfigure <strong>SkyView</strong> Network under SETUP MENU > NETWORK SETUP >CONFIGURE…d. Confirm all <strong>SkyView</strong> Network components are found.e. Confirm all settings, calibrations, and behaviors are as expected. <strong>Dynon</strong>recommends using the Installation Guide to walk through each set up section toconfirm proper system operation.5. If you do not have a settings backup, use the <strong>SkyView</strong> Installation Guide to perform ALLsetup and configuration steps as if the entire system is being installed for the first time.SV-D1000/D700 Display, when other display is part of a multi-display system in theaircraft1. Confirm that your OTHER (still installed) <strong>SkyView</strong> displays are running the latest systemsoftware by comparing the version available at http://downloads.dynonavionics.comwith the version that is listed in SETUP MENU > SYSTEM SETUP > NETWORK SETUP >NETWORK STATUS. If they are not the same, update these displays before proceedingfurther. Instruction for updating your displays can be found in the Firmware Updatesand File Operations section of this manual.2. Reinstall the repaired display into the panel.3. Reconnect all harnesses and connections as originally installed.4. Power up the <strong>SkyView</strong> System.5. If you have settings backed up from the repaired display from its pre-repair state, loadthem using SETUP MENU > SYSTEM SOFTWARE > LOAD FILES…a. If you do not have setting backed up from the repaired display, skip to step 9.6. Ensure that ALL settings under SETUP MENU > LOCAL DISPLAY SETUP are correct.7. Set the tail number of the repaired display (SYSTEM SETUP > AICRAFT INFORMATION) toDYNON.8. Exit setup on the repaired display.9. DO NOT change any settings on the recently repaired display.15-2 <strong>SkyView</strong> System Installation Guide - Revision J
Change language