SkyView - Dynon Avionics

Accessory Installation and Configurationharness (reference the SV-D700 / SV-D1000 Electrical Installation Section for details on whichpins to use). Also ensure that the display and the Encoder Converter Module share a ground.Figure 83 illustrates the basic electrical connection between the SkyView display and theEncoder Converter module.TransponderSkyView DisplayDB37 ConnectorTXGNDSkyView Display Serial TransmitShared GroundEncoder ConverterModuleGreen WireBlack WireYellowGreenWhite/BlueBlueOrangeWhite/RedWhite/GreenWhiteWhite/BlackUnconnectedUnconnectedA1A2A4B1B2B4C1C2C4D4StrobeThe Encoder Converter Moduleis compatible with all SkyViewdisplay serial ports.RedBlackFigure 83–Encoder Converter Module Electrical Connections10-30 voltsGroundSerial Port Setup–DYNON CONVERTER FormatEnter the Serial Port Setup Menu (SETUP MENU > LOCAL DISPLAY SETUP > SERIAL PORT SETUP)on each display and configure the appropriate serial port for use with the Encoder Serial-to-Gray Code Converter module with the following settings:SERIAL # IN DEVICE:NONESERIAL # IN FUNCTION:NONESERIAL # IN/OUT BAUD RATE: 1200SERIAL # OUT DEVICE: DYNON CONVERTERCapacitance-to-Voltage Converter Installation and ConfigurationDynon Avionics’ Capacitance-to-Voltage Converter (Dynon P/N 100654-000) is suitable forgeneral use with most capacitive plate fuel level sensors. It accepts an input via a female BNCand outputs a DC voltage signal that can be read by the SV-EMS-220. It requires 10 to 15 voltsDC for power and draws minimal current. We recommend that you connect the Capacitance-to-Voltage Converter to the SV-EMS-220 for power as shown in the table below. It will also workproperly when connected directly to standard 12 volt DC aircraft power. If your aircraft runs on24 volt DC power, you must connect the Capacitance-to-Voltage Converter to the SV-EMS-220for its power source. Voltage inputs higher than 15 volts DC will damage the device.14-12 SkyView System Installation Guide - Revision J