SkyView - Dynon Avionics

Accessory Installation and ConfigurationOnce you are flying straight and level at a safe altitude for stalls, go into the AOA CalibrationWizard (IN FLIGHT SETUP MENU > AOA CALIBRATION…) and follow the onscreen instructions tocalibrate angle of attack.Encoder Serial-to-Gray Code Converter Installation and ConfigurationThis section guides you through the installation of Dynon’s Encoder Converter (Dynon P/N100362-000). The Encoder Converter is an electronic device that receives the serial encoderdata from a SkyView display and outputs standard Mode-C parallel Gray code into your Mode-Ctransponder.This Encoder Converter requires data from a SkyView display and is not to beconfused with other standalone encoders available on the market. The EncoderConverter does not output an encoder strobe signal.The Encoder Converter is designed to be powered off voltages between 10 and 30 volts DC.Tools and EquipmentThe following parts are not included with your Encoder Converter purchase but may benecessary to complete the installation.Wire cuttersConnector crimp toolCrimp pinsSkyView Display Harness (SV-HARNESS-D37)Connector to mate with Gray code transponderElectrical InstallationThe following sections describe the wiring requirements for using the Encoder Converter. Pleasefollow these instructions explicitly as improper wiring can result in permanent damage to your unit.Recommended Wire PracticesUse correct splicing techniques for all electrical connections, taking care to properlyinsulate any exposed wire. A short circuit between any of the wires may causedamage to the Encoder.The wire used in construction of your Encoder Converter is 22 AWG avionics grade Tefzel wire,which meets Mil Standard MIL-W-22759/16.Make sure all connections are secure and all wires are routed and strain relievedto ensure that the wires will not chafe against any other object in the aircraft.14-10 SkyView System Installation Guide - Revision J