SkyView - Dynon Avionics

Accessory Installation and ConfigurationPlumbingFigure 82–Boom Mount AOA/Pitot Probe DimensionsBecause the pitot and AOA plumbing tubes have not been annealed, they workhardenrapidly when manipulated. Make gentle bends, and only bend any givensection once.After mounting the probe, route the pitot and AOA lines from the probe to the SV-ADAHRS-20X.The tube closest to the snout is the pitot line, while the tube in the rear is the AOA line. There isno static source on the probe.After mounting the probe, install tubing interface hardware to connect the 3/16 plumbing linesfrom the probe to whatever plumbing lines run back to the SV-ADAHRS-20X in your aircraft.Make sure the plumbing lines do not chafe or interfere with any aircraft control systems.Pressure CheckDynon’s pitot design deliberately has a pin-sized leak hole in each of the two tubes to permitdraining any moisture which might accumulate inside. These holes are located in the middle ofthe tube at the bottom. Plugging these holes does not guarantee a pneumatic seal (althoughone is sometimes present). The leak that may exist does not affect the performance of theprobe. You will, however, need to take it into account when doing pressure/leak tests on yourpitot system.CalibrationIt is your responsibility to fly your plane safely while performing any configurationor calibration in flight. The best scenario includes a second person to perform anynecessary steps on any SkyView components.You should familiarize yourself with the AOA calibration procedure before flight byreading through the instructions in the AOA Calibration Wizard (SETUP MENU >HARDWARE CALIBRATION > ADAHRS CALIBRATION > AOA CALIBRATION).SkyView System Installation Guide - Revision J 14-9