SkyView - Dynon Avionics

SV-ARINC-429 Installation and Configuration> LICENSE > LICENSE CODE. If you have more than one display in the aircraft, choose oneto install it onto and provide information for only that display. Once any display islicensed, all connected displays in the Aircraft can use the Vertical Power softwarefeatures.4. An SV-VPX-290 VP-X Software Certificate may be purchased from Dynon Avionics or anyauthorized Dynon Avionics retailer. This certificate can be redeemed for a license codethat can be entered in SETUP MENU > LOCAL DISPLAY SETUP > LICENSE > LICENSE CODE.To redeem a certificate simply follow the instructions on the certificate itself. Similar tothe above, you will need to redeem your certificate by visitinglicense.dynonavionics.com with your SkyView display model and serial number ready.Alternatively, you can call Dynon Avionics directly at 425-402-0433 to redeem acertificate.Physical and Electrical InstallationRefer to the Vertical Power installation documentation for instructions on the physical andelectrical installation of the VP-X system.Up-to-date installation manuals, wiring diagrams, and “how-to” guides for the VP-X system canbe found at http://www.verticalpower.com/documents.html.Serial Port ConnectionAll communication between the VP-X system and SkyView is accomplished via a singlebidirectional a serial connection. To accomplish this:Choose an unused serial port on each display to connect the VP-X to. Note that both theTX and RX sides of the serial port are needed, and both the RX and TX lines must beconnected to all displays in parallel. It is helpful, but not required, to choose the samenumerical serial port on each display. This lets you configure each display’s serial portsidentically.Connect the VP-X serial TX wire from VP-X connector J1, pin 20 to the SkyView serial RXof your choosing. If you have multiple displays, the VP-X TX wire must be connected to aserial RX wire on each display.Connect the VP-X serial RX wire from VP-X connector J1, pin 22 to the SkyView serial TXof your choosing. If you have multiple displays, the VP-X RX wire must be connected to aserial TX wire on each display.Connect VP-X the VP-X ground wire from VP-X connector J1, pin 21 any of the groundwires on the SkyView D37 connector (any of pins 21-24)Record the SkyView serial port that you have chosen on each display as you will need toconfigure it later for use with the VP-X.13-2 SkyView System Installation Guide - Revision J