SkyView - Dynon Avionics

SV-ARINC-429 Installation and ConfigurationSV-ARINC-429 Related SettingsGo to the ARINC-429 SETUP under SETUP MENU > SYSTEM SETUP > ARINC-429.SkyView supports up to two SV-ARINC-429 modules, but since most aircraft will only have oneinstalled, the “MODULE 2” section is normally disabled. If your aircraft does actually have twoSV-ARINC-429 modules, note that the serial numbers of each module are provided so you candetermine which module is which.For each module, Set INPUT1 to the type of device connected to the SV-ARINC-429’s ARINC-429RX 1 A and B inputs, any of GPS X or NAV X. The numerical designation of the device determineswhat it will be called on the HSI. Note that any GPS/NAV slots that are highlighted in red arealready being used for other devices. Also note that though POS X is a possible setting, it shouldgenerally not be used for ARINC devices.Next set the INPUT SPEED parameter (HIGH or LOW), based on the output speed of your twoARINC devices.The SV-ARINC-429 has one ARINC output channel with 2 sets of pins on the connector for wiringconvenience. If one or both of your ARINC devices can accept commands, configure OUTPUTSPEED appropriately.If you have connected a device to ARINC-429 RX 2 A and B, repeat the above configuration forthe INPUT2 parameter; otherwise, leave it set to NONE.Your ARINC-429 capable GPS and/or NAV will need to be configured appropriately as well.Suggested settings for common devices can be found at http://wiki.dynonavionics.com.SkyView System Installation Guide - Revision J 12-9