You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>SkyView</strong> Network ConnectionAutopilot Servo Installation, Configuration, and CalibrationConnect the servos to the <strong>SkyView</strong> network according to Figure 53 and Table 39. Installersshould strongly consider using the SV-NET-SERVO cabling kit (one per servo) for completing thenetwork connection to the servos in the system. Figure 54 is the recommended pin insertionscheme for the three DB9 connectors present in the SV-NET-SERVO cabling kit.Kit ContentsSPLICERED - 20 AWG - To Servo Power Switch/BreakerSPLICEBLACK - 20 AWG - To Aircraft GroundREDBLACKYELLOWSPLICEYELLOW - To Disengage/CWS ButtonSERVO(SV32, SV42,or SV52)WHITE/BLUEWHITE/GREEN95CONNECT5 59 9WHITE/BLUEWHITE/GREENTo <strong>SkyView</strong>NetworkBLUEGREEN61SV-NET-SERVO KitMale DB9 ConnectorPin Insertion View16SV-NET-SERVO KitFemale DB9 ConnectorPin Insertion ViewBLUEGREEN16SV-NET-SERVO KitFemale DB9 ConnectorPin Insertion ViewAll wires in the kit are 20 feet long and 22 AWG unless otherwise specified.Figure 54–SV-NET-SERVO Recommended Pin Insertion (All Connectors Rear View)Note that the kit contains 20 feet of wire of each color, which should be sufficient for mostservo installations. Also note that the white/blue, white/green and blue, green wirecombinations come pretwisted.Remember to configure the network after connecting all modules to a display.AP Disengage/CWS ButtonThe installation of the AP Disengage/CWS button is required.The AP Disengage/CWS button should be in a very accessible location, usually mounted to thestick or yoke. This button’s primary purpose is to immediately disengage the autopilot. It is alsorequired for autopilot calibration, control wheel steering functionality, and can be used toengage the autopilot.This button should be a single pole, normally open, momentary button. Verify that twoterminals of the button are shorted when the button is pressed and open (no-connect) whenthe button is released. One terminal of the button should connect to the servos’ yellow wires,and the other should connect to ground.<strong>SkyView</strong> System Installation Guide - Revision J 10-11
Change language