SkyView - Dynon Avionics

Autopilot Servo Installation, Configuration, and CalibrationAutopilot System Electrical InstallationFigure 53 provides an overview of the autopilot electrical system. Note that SkyView supportsup to two servos.SPLICERED - 20 AWG - To Servo Power Switch/BreakerREDBLACKYELLOWSPLICESPLICEBLACK - 20 AWG - To Aircraft GroundYELLOW - To Disengage/CWS ButtonPilot accessibleservo powerswitch/breakerTo AircraftPower(10 to 30 volts)SERVO(SV32, SV42,or SV52)WHITE/BLUEWHITE/GREEN95CONNECT5 59 9WHITE/BLUEWHITE/GREENTo SkyViewNetworkBLUEGREEN6116BLUEGREEN16Male DB9Female DB9Twisted Pair8-10 twists/footFemale DB9Pilot-accessibleDisengage/CWS button(Normally open, momentary)Usually mounted to the stickSPLICERED - 20 AWG - To Servo Power Switch/BreakerSERVO(SV32, SV42,or SV52)REDBLACKYELLOWWHITE/BLUEWHITE/GREENSPLICESPLICE59CONNECTBLACK - 20 AWG - To Aircraft GroundYELLOW - To Disengage/CWS Button5 59 9WHITE/BLUEWHITE/GREENTo SkyViewNetwork5 kohmOptional resistor forbroken disengagedetectionBLUEGREEN6116BLUEGREEN16Male DB9Female DB9Twisted Pair8-10 twists/footFemale DB9Servo- SERVO CURRENT DRAW AT 12 VOLTS -(halve the current for 24 volt systems)Engaged,Powered,holding,disengaged100% torqueEngaged,moving,100% torqueUnitSV32 0.10 0.80 1.33 ampsSV42 0.10 1.11 2.03 ampsSV52 0.10 1.52 2.80 ampsFigure 53–SkyView Autopilot System Electrical Installation Overview (All Connectors Rear View)The following sections describe the electrical installation of each subsystem in detail.SkyView System Installation Guide - Revision J 10-9