UlTrEX MOTOr OIl SaE 40W - TESCO Corporation

TESCO SECTION 1Material Safety Data SheetULTREX MOTOR OilSAE 40WGeneral InformationMSDS Bulletin 83200eDate of Issue 02/23/2006Supercedes n/aPage of 5Chemical Name & Synonyms:N/AChemical Family:PETROLEUM HYDROCARBON BLENDManufacturer’s Name:Address:Trade Name & Synonyms:ULTREX MOTOR OIL SAE 40WFormula Mixture:XTESCO CORPORATION6204 6A STREET, S.E.CALGARY, ALBERTA, CANADAT2H 2B7Prepared By:R Mohochi/ChemistProduct Code Number: 731135Emergency Phone Number: 800-424-9300SECTION 2HAZARDOUS INGREDIENTSTHE HAZARDS PRESENTED BELOW ARE THOSE OF THE INDIVIDUAL COMPONENTS:Chemical Name (Ingredients): SOLVENT REFINED PETROLEUM DISTILLATESPercent: 75-100Hazard:IRRITANTTLV: 5 MG/M3 $1PEL: 5 MG/M3 $2STEL:10 MG/M3$1CAS#: $$Chemical Name (Ingredients): MINERAL OILPercent: 1-10Hazard:IRRITANTTLV: 5 MG/M3 $1PEL: 5 MG/M3 $2STEL:10 MG/M3$1CAS#: 8012-95-1Chemical Name (Ingredients):Percent:Hazard:TLV:PEL:STEL:CAS#:$ OIL MIST VALUESChemical Name (Ingredients): ZINC ALKYLDITHIOPHOSPHATEPercent: 1-5Hazard:IRRITANTTLV: N/E 1PEL: N/E 2STEL:N/ECAS#: 68649-42-3SECTION 2a NON-HAZARDOUS INGREDIENTSChemical Name (Ingredients): $$ 64741-88-4, 64742-54-7Percent:Hazard:TLV:PEL:STEL:CAS#:(NON-HAZARDOUS INGREDIENT NAMES AND CAS NUMBERS ARE PROTECTED UNDER NJ TRADE)Secret Registry #: 409363-5361PSECTION 3PHYSICAL DATABoiling Point (f): 450ºSpecific Gravity (H20=1): 0.88Vapor Pressure (MM HG): 1Odor:PETROLEUMPH @ 100%:N/AClarity:TRANSPARENTVolatile by Volume: 0Evaporation Rate (BU A/C=1):

Material Safety Data SheetULTREX MOTOR OilSAE 40WPage of 5SECTION 4FIRE AND EXPLOSION HAZARDFlash Point: 430ºF / C.O.CFlammable Limits: PETROLEUM OIL LEL: N/E UEL:N/EExtinguishing Media: Foam: X Alcohol Foam: CO2: XDry Chemical: X Water Spray: X Other: XSpecial Fire Fighting Procedures:FIREFIGHTERS SHOULD WEAR A SELF-CONTAINED BREATHING APPARATUS AND FULLPROTECTIVE GEAR. HALON MAY ALSO BE USED TO EXTINGUISH FIRES. COOL FIRE-EXPOSEDCONTAINERS WITH WATER SPRAY TO PREVENT BURSTING.Unusual Fire and Explosion Hazards:THE USE OF WATER SPRAY (F0G) WHILE EFFECTIVE, MAY CAUSE FROTHING AND FOAMING.NEVER USE A WATER JET AS THIS WILL JUST SPREAD THE FIRE. USE CARE AS SPILLS MAY BESLIPPERY.Aerosol Level (NFPA 30B):NFPA 704 Hazard Rating:SECTION 5N/A(0=Insignificant 1=Slight 2=Moderate 3=High 4=Extreme)Health: 1 Flammability: 1 Instability: 0 Special:HEALTH HAZARD DATAThreshold Limit Value: 5 MG/M3 AS OIL MIST 1.Effects of Overexposure:-Acute(Short Term Exposure)EYE CONTACT: MAY CAUSE IRRITATION SEEN AS STINGING, TEARING, AND REDNESS. SKINCONTACT: PROLONGED CONTACT MAY CAUSE IRRITATION SEEN AS ITCHING AND REDNESS.PROLONGED OR REPEATED CONTACT AS FROM CLOTHING WET WITH MATERIAL MAY CAUSEDRYING, DEFATTING, AND CRACKING OF THE SKIN. INJECTION UNDER THE SKIN, IN MUSCLE, ORINTO THE BLOOD STREAM CAN CAUSE IRRITATION, INFLAMMATION, SWELLING, FEVER, ANDSYSTEMIC EFFECTS, AND MILD CENTRAL NERVOUS SYSTEM DEPRESSION. INJECTION OFPRESSURIZED HYDROCARBONS CAN CAUSE SEVERE, PERMANENT TISSUE DAMAGE. INITIALSYMPTOMS MAY BE MINOR. INHALATION: MIST MAY CAUSE RESPIRATORY IRRITATION SEEN ASCOUGHING AND SNEEZING. INGESTION: MAY CAUSE IRRITATION WITH POSSIBLE NAUSEA,VOMITING, AND DIARRHEA.-Chronic (Long Term Exposure)ON RARE OCCASIONS, PROLONGED AND REPEATED EXPOSURE TO OIL MIST POSES A RISK OFCHRONIC LUNG INFLAMMATION. THIS CONDITION IS USUALLY ASYMPTOMATIC AS A RESULT OFREPEATED SMALL ASPIRATIONS. SHORTNESS OF BREATH AND COUGHING ARE THE MOSTCOMMON SYMPTOMS. SIGNS OF LUNG INVOLVEMENT INCLUDE INCREASED RESPIRATION ANDHEART RATES AS WELL AS A BLUISH DISCOLORATION OF THE SKIN. CHRONIC SKIN CONTACT MAYPROMOTE DERMATITIS AND OIL ACNE. IN RARE CASES, CHRONIC SKIN EXPOSURE MAY RESULTIN AN INCREASED SENSITIVITY TO SUNLIGHT (PHOTOSENSITIVITY). MEDICAL CONDITIONSAGGRAVATED BY EXPOSURE ARE PRE-EXISTING RESPIRATORY AND SKIN CONDITIONS SUCH ASASTHMA, EMPHYSEMA, AND DERMATITIS. TARGET ORGANS: NONE KNOWN. THERE IS NOPRIMARY ROUTE OF ENTRY INTO THE BODY. THE PRIMARY ROUTES OF EXPOSURE ARE SKIN ANDEYE CONTACT.Primary Routes of Entry: Inhalation: Ingestion: absorption:Emergency and First Aid Procedures:-Inhalation:REMOVE FROM THE AREA TO FRESH AIR. SEEK MEDICAL ATTENTION IF RESPIRATORY IRRITATIONDEVELOPS OR IF BREATHING BECOMES DIFFICULT.-Eye Contact:RINSE THE EYES WITH WATER. REMOVE ANY CONTACT LENSES AND CONTINUE FLUSHING WITHPLENTY OF WATER FOR SEVERAL MINUTES. SEEK MEDICAL ATTENTION IF IRRITATION DEVELOPS.-Skin Contact:WIPE AWAY MATERIAL WITH A CLOTH. WASH WITH SOAP AND WATER. SEEK MEDICAL ATTENTIONIF IRRITATION DEVELOPS. CLEAN CLOTHING AND SHOES.-Ingestion:GIVE 3 TO 4 GLASSES OF WATER, BUT DO NOT INDUCE VOMITING. IF VOMITING OCCURS, GIVEFLUIDS AGAIN. SEEK MEDICAL ATTENTION IF DISCOMFORT OCCURS.-Notes to Physician:THERE IS NO SPECIFIC ANTIDOTE. TREAT THE PATIENT SYMPTOMATICALLY. IN THE EVENT OFINJECTION IN UNDERLYING TISSUE, IMMEDIATE TREATMENT SHOULD INCLUDE EXTENSIVE

SECTION 6Material Safety Data SheetULTREX MOTOR OilSAE 40WINCISION, DEBRIDEMENT, AND SALINE IRRIGATION. INADEQUATE TREATMENT CAN RESULT INISCHEMIA AND GANGRENE. EARLY SYMPTOMS MAY BE MINIMAL.TOXICITY INFORMATIONPage of 5Product Contains Chemicals Listed as Carcinogen or Potential Carcinogen By:IARC: No NTP: No OSHA: NoACGIH: NoOTHER: NoVOC CONTENT: 0% BY WEIGHT; 0% BY VOLUME; 0 G/LSOLVENT REFINED PETROLEUM DISTILLATES ( 2 G/KG 3.SKN-RBT LD50: > 2 G/KG 3.IHL-RAT LC50: > 5 MG/L 3.EYE-RBT DRAIZE SCORE BETWEEN 6 AND 15, PRACTICALLYNON-IRRITATING 3.SKN-RBT DRAIZE SCORE BETWEEN .5 AND 3, PRACTICALLYNON-IRRITATING 3.MINERAL OIL (

Material Safety Data SheetULTREX MOTOR OilSAE 40WPage of 5SECTION 9Required Ventilation:Respiratory Protection:Glove Protection:Eye Protection:Other Protection:SECTION 10SPECIAL PROTECTION INFORMATIONGENERAL VENTILATION IS NORMALLY ADEQUATE. LOCAL VENTILATION IS RECOMMENDED TOCONTROL EXPOSURE FROM OPERATIONS THAT CAN GENERATE EXCESSIVE LEVELS OF MISTS.LOCAL VENTILATION IS PREFERRED, BECAUSE IT PREVENTS DISPERSION INTO WORK AREAS BYCONTROLLING IT AT ITS SOURCE.NONE REQUIRED UNDER NORMAL CONDITIONS OF USE. RESPIRATORS SHOULD BE SELECTEDBY AND USED UNDER THE DIRECTION OF A TRAINED HEALTH AND SAFETY PROFESSIONALFOLLOWING REQUIREMENTS FOUND IN OSHA’S RESPIRATOR STANDARD (29 CFR 1910.134) ANDANSI’S STANDARD FOR RESPIRATORY PROTECTION (Z88.2-1992). FOR CONCENTRATIONS ABOVETHE TLV AND/OR PEL BUT LESS THAN 10 TIMES THESE LIMITS, A NIOSH APPROVEDHALF-FACEPIECE RESPIRATOR EQUIPPED WITH APPROPRIATE CHEMICAL CARTRIDGES MAY BEUSED. FOR CONCENTRATIONS GREATER THAN 10 TIMES THE TLV AND/OR PEL, CONSULT THENIOSH RESPIRATOR DECISION LOGIC FOUND IN PUBLICATION NO. 87-116 OR ANSI Z88.2-1992.NEOPRENE OR NITRILE RUBBER GLOVES IF REPEATED OR PROLONGED SKIN CONTACT ISLIKELY. ENSURE COMPLIANCE WITH OSHA’S PERSONAL PROTECTIVE EQUIPMENT (PPE)STANDARD FOR HAND PROTECTION, 29 CFR 1910.138.SAFETY GLASSES WITH SIDE SHIELDS IF THE METHOD OF USE PRESENTS THE LIKELIHOOD OFEYE CONTACT. ENSURE COMPLIANCE WITH OSHA’S PERSONAL PROTECTIVE EQUIPMENT (PPE)STANDARD FOR EYE AND FACE PROTECTION, 29 CFR 1910.133.WEAR GENERAL DUTY WORK CLOTHING AND SHOES. A SAFETY SHOWER AND AN EYEWASHSTATION SHOULD BE AVAILABLE. REMOVE OIL SOAKED CLOTHING AND SHOES. WASH CLOTHINGAND CLEAN SHOES BEFORE REUSE.STORAGE AND HANDLING INFORMATIONStorage Temperature: Indoors: X Outdoors: X Heated: Refrigerated:Minimum Temperature: 35ºF Maximum Temperature: 120ºFPrecautions to be taken in Handling and Storing:ALWAYS STORE MATERIAL IN ITS ORIGINAL CONTAINER. KEEP CONTAINER TIGHTLY CLOSEDWHEN NOT IN USE. EMPTY CONTAINERS MAY CONTAIN PRODUCT RESIDUES WHICH MAY EXHIBITTHE HAZARDS OF THE PRODUCT. TO AVOID POSSIBLE EXPLOSION DO NOT PRESSURIZE, CUT,WELD, SOLDER, DRILL, GRIND, OR EXPOSE EMPTY CONTAINERS TO HEAT, HOT SURFACES,SPARKS, OR OPEN FLAMES. BULK STORAGE: FOR MAXIMUM PRODUCT LIFE, STORE INDOORS.OUTDOOR STORAGE TIP: STORE CONTAINERS ON THEIR SIDE TO HELP PREVENT WATERACCUMULATION ON A FLAT END AND CONSEQUENT PRODUCT CONTAMINATION.Other Precautions:SECTION 11KEEP OUT OF REACH OF CHILDREN. READ THE ENTIRE LABEL BEFORE USING PRODUCT.FOLLOW THE LABEL DIRECTIONS.REGULATORY INFORMATIONChemical Name CAS Number Upper % LimitZINC COMPOUNDS N/A 5Those Ingredients listed above are subject to the reporting requirements of 313 of Title III and of theSuperfund Amendments and Reauthorization Act of 1986 and 40 CFR part 372.CALIFORNIA PROPOSITION 65WARNING: This product contains the following chemical(s) know to the State of California to cause(1)Cancer or (2)Birth Defects or other reproductive harm. THIS PRODUCT CONTAINS NONE.SECTION 12REFERENCES1. THRESHOLD LIMIT VALUES FOR CHEMICAL SUBSTANCES AND PHYSICAL AGENTS ANDBIOLOGICAL EXPOSURE INDICES, ACGIH, 2005.2. OSHA PEL.3. VENDOR’S MSDS.4. REGISTRY OF TOXIC EFFECTS OF CHEMICAL SUBSTANCES, CCINFOWeb, 2006.ALL THE COMPONENTS OF THIS PRODUCT ARE IN COMPLIANCE WITH THE TOXIC SUBSTANCESCONTROL ACT (TSCA) AND ARE EITHER LISTED ON THE TSCA INVENTORY OR OTHERWISEEXEMPTED FROM LISTING.

Material Safety Data SheetULTREX MOTOR OilSAE 40WIRR:IRRITANT, FLAM/FLAMM:FLAMMABLE, COMB:COMBUSTIBLE, CORR:CORROSIVECARC:CARCINOGENIC, TOX:TOXIC, N/A:NOT APPLICABLE, N/E:NOT ESTABLISHED,COC:CLEVELAND OPEN CUP, PMCC:PENSKY-MARTIN CLOSED CUP, TCC:TAGLIABUE CLOSED CUP,LEL:LOWER EXPLOSION LIMIT, UEL:UPPER EXPLOSION LIMIT, NFPA:NATIONAL FIRE PROTECTIONASSOCIATION, IARC:INTERNATIONAL AGENCY FOR THE RESEARCH ON CANCER, NTP:NATIONALTOXICOLOGY PROGRAM, OSHA:OCCUPATIONAL SAFETY & HEALTH ADMINISTRATION,ACGIH:AMERICAN CONFERENCE OF GOVERNMENTAL INDUSTRIAL HYGIENISTS, TLV:THRESHOLDLIMIT VALUE, PEL:PERMISSIBLE EXPOSURE LIMIT, STEL:SHORT-TERM EXPOSURE LIMIT,MLD:MILD, MOD:MODERATE, SEV:SEVERE, MUT:MUTAGENIC, ASPHYX:ASPHYXIANT,PNOS:PARTICLES (INSOLUBLE) NOT OTHERWISE SPECIFIED, SDT:STANDARD DRAIZE TEST,ORL:ORAL, IHL:INHALATION, HMN:HUMANTHE INFORMATION CONTAINED HEREIN IS BASED ON DATA CONSIDERED ACCURATE IN LIGHT OFCURRENT FORMULATION. HOWEVER, NO WARRANTY IS EXPRESSED OR IMPLIED REGARDINGTHE ACCURACY OF THESE DATA OR THE RESULTS TO BE OBTAINED FROM THE USE THEREOF.MATERIAL SAFETY DATA SHEETOIL, MOTOR, SAE 40W TESCOPage of 5Global Locations:CanadaCalgary, AlbertaEmail: CABU_Sales@tescocorp.comAsia PacificJakarta, IndonesiaEmail: APBU_Sales@tescocorp.comScotlandAberdeen, AberdeenshireEmail: EURO_Sales@tescocorp.comUnited StatesHouston, TexasEmail: USBU_Sales@tescocorp.comArgentina, Bolivia, Brasil,Colombia, Ecuador, Mexico,Trinidad, VenezuelaBuenos Aires, ArgentinaEmail: LABU_Sales@tescocorp.comMiddle East & AfricaJebel Ali Free ZoneUnited Arab EmiratesEmail: MEABU_Sales@tescocorp.comChinaChaoyang District , Beijing,Email: CHINA_Sales@tescocorp.comRussiaMoscowEmail: RUSSIA_Sales@tescocorp.comTESCO Printed in Canada