Nokia Network Voyager Reference Guide for IPSO 6.0 - Check Point

Gigabit Ethernet InterfacesTable 4 Gigabit Ethernet Interface ParametersParameterDescriptor SizeIP Address & MaskLengthDescriptionThe number of descriptors the system uses to temporarily store packets. See“Configuring the Descriptor Size” for more information.Default is 128; the acceptable values are 128, 256, and 512..You can add multiple IP addresses.NoteDo not change the IP address you use in your browser to access Network Voyager.If you do, you can no longer access the IP security platform with your Networkbrowser.Logical NameCommentsUse this to enter a more meaningful name for the interface.(Optional) This field is displayed on the main Interface Configuration and theLogical Interface pages. Use it to add a description that you might find useful inidentifying the logical interface.NoteLink speed is fixed and duplex mode is set to full at all times for Gigabit Ethernet interfaces.To configure a Gigabit Ethernet interface1. Click Interfaces under Configuration > Interface Configuration in the tree view.2. Click the physical interface link to configure. Example: eth-s5p1.3. Set flow control to On.4. Click Apply.5. Click the name of the logical interface in the logical interfaces table.The Logical Interface page is displayed.6. (Optional) To increase the maximum length of frames, in bytes, that can be transmitted overthis device, enter a value for MTU. The default is 1500.7. Enter the IP address and subnet mask length for the device in the appropriate text fields.8. Enter the IP address and mask length.Click Apply.Each IP addresses and mask length that you add are added to the table when you clickApply. The entry fields return to blank to allow you to add more IP addresses.Use the delete check box to delete IP addresses from the table.Nokia Network Voyager Reference Guide for IPSO 6.0 37