Supplement to the Canopy System Release 8 User Guide PMP 400

PMP 400 and PTP 200 SeriesCanopy User Guide Supplement3. Connect the radio to theantenna by sliding it into thecaptive space. Secure theradio to the antenna using thetwo bolts provided.4. Weatherproof the connectorusing standard practices, withwaterproof wrap.5. Use standard work and safetypractices for tower climbing,and connect the upperassembly to a pole, mountingfixture, or the tower.6. Adjust downtilt as desired, perprevious calculations doneduring Planning. If any doubts,confirm downtilt after the radiois operational using SMs in thefield at selected test locations.=========================== end of procedure ======================Procedure 4: Cabling and Grounding/Earthing the AP1. Standard Canopy installation practices apply, including using shielded Ethernet cablefor all infrastructure cabling, using drip loops, providing extra cable for future use atany termination, and ensuring the tower or structure is fully grounded (ProtectiveEarth – PE).2. Use dielectric grease on all connections and in all RJ-45 Ethernet connectors.(Dielectric grease is generally available in the trade, and is specially formulated so asto be uniformly non-conducting.) The best practice is to use enough grease to fill theRJ-45 female connector, and then insert the RJ-45 male connector and push thegrease further into the Canopy unit and around the RJ-45 connector. Excess greaseIssue 3, January 2009 Page 33 of 45