Supplement to the Canopy System Release 8 User Guide PMP 400

More documents

Recommendations

Info

PMP 400 and PTP 200 SeriesCanopy User Guide SupplementFigure 6: Region Code on AP “Configuration => General” pageAn SM or BHS has both a configurable Region Code and, once it registers to an AP or BHM, anactive Region Code. After an SM/BHS registers to an AP/BHM, it uses the Region of the AP/BHMto determine its DFS behavior and displays the AP’s or BHM’s Region Code on its Home =>General Status page, as shown in Figure 8.The two Region Codes should be the same in normal operation, but will not be the same if, forexample, as shown in Figure 7 and Figure 8, an SM configured with a Region Code of “None” hasregistered to an AP with a Region Code of Europe.Issue 3, January 2009 Page 24 of 45
PMP 400 and PTP 200 SeriesCanopy User Guide SupplementFigure 7: Configured Region Code on SM Configuration => General pageFigure 8: Active Region Code on SM Home => General Status pageThe AP or BHM always operates under its manually configured Region Code (the one on theConfiguration => General page), and so does not show a Region Code on its Home => GeneralStatus page.Under normal operations, APs and BHMs operating with DFS (see Table 6) will experience anadditional minute after power-up or reboot before they will register any SMs or BHSs. SMs andBHSs operating with DFS (see Table 6) will experience an additional minute after they rebootbefore they will register to an AP or BHM.Issue 3, January 2009 Page 25 of 45
Page 2 and 3: PMP 400 and PTP 200 SeriesCanopy Us
Page 4: PMP 400 and PTP 200 SeriesCanopy Us

Supplement to the Canopy System Release 8 User Guide PMP 400

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?