צמנט רגיל צמנט : מסמך זה הוא הצעה בלבד מכון התקנים הישראלי

ועדה 10601EN 197-1:2011 (E)The requirement on a certain characteristic is not applicable in those Member States (MSs) where there are noregulatory requirements on that characteristic for the intended use of the product. In this case, manufacturersplacing their products on the market of these MSs are not obliged to determine nor declare the performance of theirproducts with regard to this characteristic and the option "No performance determined" (NPD) in the informationaccompanying the CE marking (see Clause ZA.3) may be used.The NPD option may not be used, however, where the characteristic is subject to a threshold level.ZA.2 Procedure for the attestation of conformity of productsZA.2.1 System of attestation of conformityThe system of attestation of conformity for the 27 distinct common cements, 7 sulfate resisting common cementsas well as 3 distinct low early strength blast furnace cements and 2 sulfate resisting low early strength blast furnacecements or low heat common cements indicated in Table ZA.1 is shown in Table ZA.2 for the indicated intendeduse(s), in accordance with the Commission Decision of 14 July 1997 (97/555/EC) published in the Official Journalof the European Communities and given in annex 3 of the Mandate for the product family “Cements”.Product(s)Table ZA.2 System of attestation of conformityIntended use(s)Level(s) orclass(es)Attestation ofconformitysystem(s)Common cements, includingcommon cements with low heatof hydration and sulfateresisting common cements aswell as low early strength blastfurnace cements and low earlystrength blast furnace cementswith low heat of hydration- Portland cements- Portland composite cementsPreparation of concrete,mortar, grout and otherPortland-slag cementmixes for construction and …… 1+Portland-silica fume cementfor the manufacture ofPortland-pozzolana cementconstruction productsPortland-fly ash cementPortland-burnt shale cementPortland-limestone cementPortland composite cement- Blast furnace cements- Pozzolanic cements- Composite cementsSystem 1+: See annex III Section 2 point (i) of Directive 89/106/EEC, with audit-testing ofsamples taken at the factoryThe attestation of conformity to common cements, including common cements with low heat of hydration andcommon cements generally accepted as being sulfate resisting as well as low early strength blast furnace cementsand low early strength blast furnace cements with low heat of hydration in Table ZA.1 shall be based on theevaluation of conformity procedures indicated in Table ZA.3 resulting from application of the clauses of thisEuropean Standard indicated therein. Clause 6 of EN 197-2:2000 gives rules relating to actions in the event of nonconformity.33