MANGANESE ORE SINTERING MISCONCEPTS AND FACTS - IIM

More documents

Recommendations

Info

FIFTH MISCONCEPTFines of -1mm or -0.5mm in size can not be sintered.FACT• Fines (all -1mm with more than 50% -0.5 mm fraction)can also be sintered.• Achievable through control of balling method, moisturecontrol, coke size, permeability & suction control.10
RECOMMENDATIONS• Please get to know your ore – not only chemical analysis but itsmineralogy and mineral association also.• Every deposit is different than other. Response to sinteringprocess parameters may be different.• Conduct basic sintering study to understand amenability of yourore to sintering. A small amount invested in R&D study will bebeneficial & cost saving in the long run.• Overcome the fear and misconcept about Mn Ore sinters, withpragmatic thinking.11
Page 1 and 2: MANGANESE ORE SINTERINGMISCONCEPTS
Page 3 and 4: COMPANY INTRODUCTION• Established
Page 5 and 6: FIRST MISCONCEPTNo need for sinteri
Page 7 and 8: SECOND MISCONCEPTDuring sintering,
Page 9: FOURTH MISCONCEPTSinters can not be
Page 13 and 14: CONCLUSIONSCharacteristics comparis
Page 15 and 16: CONCLUSIONSCharacteristics comparis
Page 17 and 18: GESPL SOLUTION FOR INDEGINEOUS SINT
Page 19 and 20: ADVANTAGES OF MINITEC-GESPL SINTER
Page 21: GESPL - A Total Solution for Benefi

MANGANESE ORE SINTERING MISCONCEPTS AND FACTS - IIM

Create successful ePaper yourself

Delete template?

Save as template?