MiniCom 3 User manual - Armatec

Commands 37Clicking on "OK" sends the data to the meter (even if you don't make any changes). "Cancel" stopscommunication with the meter.If the command doesn't run successfully, still try to read the meter using "Start Readout". Solutions toproblems during communication with meters can be found under the topic "Solving Problems".Global ParametersTime delay after selecting this commandFirst, the meter must be connected. After selecting this command, first thecurrent meter parameters are read, and then the configuration dialog isshown. We recommend using this command only after doing a meterreadout. If there is a communication error during the readout, this will beshown on the screen and you won't be able to continue in the configuration.Meter IDMeter identification number (also a part of the secondary meter address).Fabrication NumberCustomer LocationFabrication Number:The Fabrication number has nothing to do with the meter ID or Customerlocation parameters.It is assigned to the meter at the time of manufacture by Sensus MeteringSystem GmbH. It cannot be changed.© 2006 Sensus Metering System