MiniCom 3 User manual - Armatec

Meter Types 112.1 PolluThermEnergy meter - totaliser.FeaturesProtocol : MBusSupported baudrates: 300, 2400 autodetectionSupported addressing: primary, secondarySupported communication interfaces: MBus terminals (optional), optical interface, inductive interface(the inductive interface MiniPad can be connected to terminals 51 + 52)Number of counters in meter readout: 98List of supported commands· Start Readout· Set primary MBus address· Set meter ID· Set customer location· Set system date and time· Set averaging duration (Registered version only)· Reset min/max values (Registered version only)· Set LCD option (Registered version only)· Set tariff parameters (Registered version only)· Read logger values (Registered version only)· Set bus credit (Registered version only)Activation of a meter using optical interface:For meter communication via optical interface it is necessary to activate themeter display first. If the display blinks, it isn't activated. You have to hold thered button for 2 seconds.To activate the optical interface and enable communication, you have to holdthe red button for another 3 seconds. The interface remains active for 3minutes, after which it is necessary to reactivate the optical interface.System date and time:For some types of meter (PolluTherm, PolluStat E, PolluCom E) it is onlypossible to set values for the date and time which are higher than the currentvalues. Be cautious: before setting the values, check them thoroughly. Thehigher values cannot be changed.© 2006 Sensus Metering System