TANK TEMPERATURE CONTROLLER - GW Kent
TANK TEMPERATURE CONTROLLER - GW Kent TANK TEMPERATURE CONTROLLER - GW Kent
TPU.Option ofmeasure unit oftemperature C/FCELFAHCELMeasure unit degree Celsius orFahrenheit.FIL Input Filter 0 to 60vz5 vzTime constant of input signal filter.SAF Safe ModenoACoLHEAnoAselection of mode in case of errornoA both outputs disabledCoL cooling output enabledHEA. .heating output enabledcoACommunicationAddress1 to 9991 Controller addresstStReset,Test,CorrectionInIEECorEndInIInI - Resetting parameters to presetvaluesEE - eprom testCor - temperature adjustEnd - exit by entering parametersWhen tSt is displayed, select the desired option by pressing ▲▼and confirm it bypressing [SET] button.Inl - resets all the parameters to the initial, preset values.EE - tests eprom. After the test the display shows:EGd - eprom functioning normallyBad - eprom corrupt5. Technical data of the controller:Display of value: -9.9°C to 99.9°C or 14.1211FResolution: 0.1°C (100°F IS 0.1°F ;Over 100°F is 1°F)Deviation: max ± 0.5°C(±D.99°F)Consumption:
6. Schematic connectionsFor the most accurate wiring info - check the back of your controller.Older controllers required 24VDC power supply for operation.Newer controllers - that operate with 24VAC - they can operate with either a:- 24VDC power supply or a- 24VAC transformer.All the 24VDC solenoids - will only work with a 24VDC power supply.If using 24VDC – observe polarity:(-) to the white wire(+) to the yellow wire – and one side of the solenoid.One side of the 24V Solenoids is connected to the yellow wire to the controller and the 24Vsupply.The other side is connected:- to the gray control wire for cooling– or the brown wire for heating.
- Page 1 and 2: TANK TEMPERATURE CONTROLLERC2105 QU
- Page 3 and 4: The following abbreviations are use
- Page 5 and 6: 2.4. TroubleshootingError codes :-E
- Page 7: status, heat,HSCCoolinghysteresis0.
TPU.Option ofmeasure unit oftemperature C/FCELFAHCELMeasure unit degree Celsius orFahrenheit.FIL Input Filter 0 to 60vz5 vzTime constant of input signal filter.SAF Safe ModenoACoLHEAnoAselection of mode in case of errornoA both outputs disabledCoL cooling output enabledHEA. .heating output enabledcoACommunicationAddress1 to 9991 Controller addresstStReset,Test,CorrectionInIEECorEndInIInI - Resetting parameters to presetvaluesEE - eprom testCor - temperature adjustEnd - exit by entering parametersWhen tSt is displayed, select the desired option by pressing ▲▼and confirm it bypressing [SET] button.Inl - resets all the parameters to the initial, preset values.EE - tests eprom. After the test the display shows:EGd - eprom functioning normallyBad - eprom corrupt5. Technical data of the controller:Display of value: -9.9°C to 99.9°C or 14.1211FResolution: 0.1°C (100°F IS 0.1°F ;Over 100°F is 1°F)Deviation: max ± 0.5°C(±D.99°F)Consumption:
Change language