TILT-UP CONSTRUCTION - Brock White

Coil InsertsT-2 Double Pick-up Insert• Available to fit 1" or 1-1/2" diameter coil bolts.• Available with plastic tipped feet or stainless steeltipped feet.15” with 1-1/2” Diameter Coils12” with 1” Diameter Coils• Available with insert locator plugs installed..375” Diameter• Designed for use with T-8 lifting angle.• Insert is setback 3/8" from panel face..375” Diameter LegsPanel Thickness and Safe Working Load per Insert (lbs.)• For proper bolt length see page 62.PL/2 L/2Lifting SystemsCoil InsertsCoil Diameter 4” 5” 5-1/2” 6” 7” 8”1” 5,400 8,100 9,400 10,800 13,500 16,0001-1/2” --- --- --- 12,600 15,000 18,000Safe working load provides a safety factor of approximately 2 to 1 in 2,500 psi concrete.DANGER! DO NOT use as an edge lifting insert, as insert is not designed for such use.See page 6 for lightweight concrete load reduction factors.To achieve SWLlifting plates must becentered oninsertsLTo Order:Specify: (1) quantity, (2) type, (3) diameter ofbolt to be used, (4) panel a thickness and insertheights, (5) with or without Insert Locator Plug,(6) plastic coated feet or stainless steel tips.Example:250 pcs. T-2 Double Pick-Up Insert, 1”diameter for 5-1/2” slab 5-1/8” insert heightwith insert Locator Plugs and plastic coatedfeet.Insert PlacementDanger! All T-2 Inserts must be positioned with thetwo coils in a horizontal line. If placed perpendicular,the shear loading (when the panel is raised to avertical position) may be concentrated on one boltonly and severe strain will occur at the cable clevisand the lifting angle gusset.Minimum EdgeDistance is 15”of Coil toEdge of ConcreteT-7S, T-7P Slotted Setting Plugs• Made of steel, or plastic continuousthreaded rod.• Used with standard coil threaded inserts toprovide void for B-14 coil bolts.• Top is cut off square so screed can passover, also slotted to accept screwdriver.• Threads and slot should be coated withnon-staining lubricant to prevent bonding.• Loosen studs within 8-24 hours for easierremoval when ready to lift.• Steel - standard sizes are 3/4”, 1”, 1-1/2” and1-1/4” diameter x 4” length. Special lengthsavailable.• Plastic - standard sizes are ¾”, 1”, and 1-1/4”diameter x 3” length.LengthTo Order:Specify: (1) quantity, (2) type, (3) diameterExample:100 sets T-7S Slotted Setting Plugs, 1-1/4”diameter04-0959