TILT-UP CONSTRUCTION - Brock White

Tilt-Up 3Lifting SystemT-90-E Tilt-Up 3 Edge Lift InsertThe Tilt-Up 3 Edge Lift Insert has an integral shear plate formaximum transfer of shear loads into the concrete. The T-90-Einsert uses FL148 4T x 11.88” Anchor and a P-99-D 4 TonDisposable Recess Plug that attachs the insert assembly to thepanel form. This Recess Plug is ordered separately.T-90-E EdgeLift InsertLifting SystemsCoil InsertsTo Order:Specify: (1) quantity, (2) nameExample:200 T-90-E Tilt-Up 3 Edge Lift Inserts.T-90-E Edge Lift Insert Selection ChartStructural PanelThicknessShear SafeWorking LoadTension SafeWorking Load4" 4,300 lbs. 4,700 lbs.5" 5,250 lbs. 5,900 lbs.6" 6,200 lbs. 7,000 lbs.7" 7,050 lbs. 8,200 lbs.EdgeLiftingSafe working load provides a safety factory of approximately2 to 1 in 2,500 psiNote: The proper method of attaching the hardware to theT-90-E insert is shown in the sketch. Make certain that thecrane applies the lifting load in a direction toward the top of thepanel or perpendicular to the casting bed. DO NOT allow thecrane to apply a load toward the bottom of the panel.T-92 Tilt-Up 3 Lifting HardwareThe T-92 Tilt-Up 3 Lifting Hardware consists of a clutchbody, curved bolt/release arm and high strength bail. Thebail is designed to readily align itself to the pull of the rigging.Once the hardware is properly engaged and under load, thehardware cannot be disengaged. Release of the hardwarefrom ground level is easily accomplished after the load hasbeen relaxed. The T-92 hardware is designed to service bothface lift and edge lift System applications.T-92Lifting InsertTo Order:Specify: (1) quantity, (2) nameExample:5 T-92 Tilt-Up 3 Lifting HardwareNote: It is a good practice to always have an extra liftingunit on hand in case the need for a spare presents itself.54 04-09