Door Visors Installation Instructions - Bernardi Acura Parts ...

21. Position the door visor as shown in steps 14and 15.23. Reinstall the door glass run channel. Seat theglass run channel properly.5 mm (0.2 in.)5mmSECTIONAL VIEWSECTIONAL VIEWDOORVISORDOORSASHDOORVISORDOORSASHBRACKETDOORGLASSRUNCHANNELDOORVISORDOOR GLASS RUNCHANNEL4319310K22. While holding light pressure on the door visor,carefully remove the adhesive backing. Using thepalm of your hand, hold the door visor firmlyagainst the door for 30 seconds.DOOR VISOR24. Check that the run channel is securely installed.25. Repeat steps 1 through 24 to install the doorvisors on the right side of the vehicle.26. Raise and lower all the windows several times toseat the glass run channels.NOTE: Whenever the battery is disconnected, thedriver’s window AUTO function is disabled.27. Start the engine. Push down on the driver’swindow switch until the window is fully open.ADHESIVE BACKING4319300K6 of 7 BII 44686 (1012) © 2010 American Honda Motor Co., Inc. - All Rights Reserved.