Door Visors Installation Instructions - Bernardi Acura Parts ...

16. Apply masking tape to the door sash along theupper, front and rear edges of the door visor asshown. Remove the door visor.19. Remove the adhesive backing from the EPT sealer.Attach the EPT sealer to the door sash, and applypressure. Apply the EPT sealer as shown, with theupper edge in contact with the door sash.MASKING TAPEEPT SEALERDOOR VISOR4319260KDOOR SASH7 mm(0.3 in.) In contactEPTSEALER17. Using isopropyl alcohol, thoroughly clean the doorsash in the area surrounded by the masking tape.Allow it to dry.18. While wearing gloves, apply the primer to the doorsash within the masked off area. Wipe up anyexcess primer at once. Allow the primer to dry forat least 3 minutes, then remove the masking tape.20. Peel back the adhesive backings, fold them over,and attach them to the front of the door visor withmasking tape.DOOR VISORSIDE VIEW4805040KSHADED SURFACE OF DOOR SASH(Thoroughly clean with isopropylalcohol before applying the primer.)2 ADHESIVE BACKINGS(Attach them to the front of thedoor visor with masking tape.)4319280K4319270K© 2010 American Honda Motor Co., Inc. - All Rights Reserved. BII 44686 (1012) 5 of 7