Door Visors Installation Instructions - Bernardi Acura Parts ...
Door Visors Installation Instructions - Bernardi Acura Parts ... Door Visors Installation Instructions - Bernardi Acura Parts ...
11. Reinstall the door glass run channel. Seat the doorglass run channel properly.SECTIONAL VIEWInstalling the Rear Door Visor13. Lower the rear door glass completely. Remove thedoor glass run channel from the door sash in thearea shown.DOORVISORDOORGLASSRUNCHANNELDOORVISORDOOR GLASSRUN CHANNEL4319240KDOOR GLASS RUNCHANNEL4319230K14. Push the two brackets on the door visor onto thedoor sash.12. Check that the run channel is securely installed.5 mm (0.2 in.)SECTIONAL VIEWDOORSASHDOORVISORDOORSASHBRACKET4319250K15. Adjust the door visor so that the distance betweenthe front edges of the door visor and door sash is5 mm (0.2 in.).4 of 7 BII 44686 (1012) © 2010 American Honda Motor Co., Inc. - All Rights Reserved.
16. Apply masking tape to the door sash along theupper, front and rear edges of the door visor asshown. Remove the door visor.19. Remove the adhesive backing from the EPT sealer.Attach the EPT sealer to the door sash, and applypressure. Apply the EPT sealer as shown, with theupper edge in contact with the door sash.MASKING TAPEEPT SEALERDOOR VISOR4319260KDOOR SASH7 mm(0.3 in.) In contactEPTSEALER17. Using isopropyl alcohol, thoroughly clean the doorsash in the area surrounded by the masking tape.Allow it to dry.18. While wearing gloves, apply the primer to the doorsash within the masked off area. Wipe up anyexcess primer at once. Allow the primer to dry forat least 3 minutes, then remove the masking tape.20. Peel back the adhesive backings, fold them over,and attach them to the front of the door visor withmasking tape.DOOR VISORSIDE VIEW4805040KSHADED SURFACE OF DOOR SASH(Thoroughly clean with isopropylalcohol before applying the primer.)2 ADHESIVE BACKINGS(Attach them to the front of thedoor visor with masking tape.)4319280K4319270K© 2010 American Honda Motor Co., Inc. - All Rights Reserved. BII 44686 (1012) 5 of 7
- Page 1 and 2: INSTALLATIONINSTRUCTIONSAccessory A
- Page 3: 7. Remove the adhesive backing from
- Page 7: 28. Pull up on the driver’s windo
11. Reinstall the door glass run channel. Seat the doorglass run channel properly.SECTIONAL VIEWInstalling the Rear <strong>Door</strong> Visor13. Lower the rear door glass completely. Remove thedoor glass run channel from the door sash in thearea shown.DOORVISORDOORGLASSRUNCHANNELDOORVISORDOOR GLASSRUN CHANNEL4319240KDOOR GLASS RUNCHANNEL4319230K14. Push the two brackets on the door visor onto thedoor sash.12. Check that the run channel is securely installed.5 mm (0.2 in.)SECTIONAL VIEWDOORSASHDOORVISORDOORSASHBRACKET4319250K15. Adjust the door visor so that the distance betweenthe front edges of the door visor and door sash is5 mm (0.2 in.).4 of 7 BII 44686 (1012) © 2010 American Honda Motor Co., Inc. - All Rights Reserved.
Change language