Actsip-H - Esco-da.be

Actron AB Main Menu 997.9.6. Communication"Setup-Communication"╔══════════════════════ Communication setup ══════════════════════╗║Default parameters║║Communication port COM2 ║║Transmission speed 19200 ║║Data bits 7 ║║Stop bits 1 ║║Parity Even ║║PLC network station number * ║║PLC network L FFH ║║PLC network U FFH ║║PLC network M 00H ║║PLC network P 00H ║║Changes in RUN allowed Yes ║╚═════════════════════════════════════════════════════════════════╝This menu lets you configure the communication parameters.7.9.6.1. Default parameters"Setup-Communication-Default parameters"Selecting "Default values" + will set standard values that will match the CPUperipheral port 19200 baud.7.9.6.2. Communication port"Setup-Communication-Communication port" toggles between the allowed communication ports COM1 and COM2. Thedefault is COM1.7.9.6.3. PLC Network station number"Setup-Communication-PLC-Network station number"Only used when communicating to COMM-H module via RS-422 interface. Set to '*'when not used.NOTE!If set to something else than '*' it will not work with RS-232communication!7.9.6.4. PLC Network L, U, M and P"Setup-Communication-PLC-Network L, U, M and P"Used when communicating to a linked PLC via the LINK-H module. Normally this isnot the case; communication is with the physically connected PLC. Then the settingshould be the following:Copyright Actron AB, 1992