Actsip-H - Esco-da.be

84 Main Menu Actron AB7.8.4.4. LINK statusThe fourth page of the PLC status looks like this:╔══════════════════════════ LINK status (4/4) ══════════════════════════╗║ ┌─────#1─────┬─────#2─────┐ #0 0123456789 ║║ LINK station number │ │ │ 00.......... ║║ Refresh (max) │ │ │ 10.......... ║║ Refresh (current) │ │ │ 20.......... ║║ Refresh (min) │ │ │ 30.......... ║║ │ │ │ 40.......... ║║ System bus error │ │ │ 50.......... ║║ Outside area setup │ │ │ 60..... Σ00 ║║ Duplicate area setup │ │ │ ║║ Outside station number │ │ │ #1 0123456789 ║║ Disconnected transfer │ │ │ 00.......... ║║ └────────────┴────────────┘ 10.......... ║║ WRF0E0-F13F WRF140-F19F 20.......... ║║ 30.......... ║║ .=Not used S=Simulation 40.......... ║║ *=Running H=Halted 50.......... ║║ O=Stopped E=Error 60..... Σ00 ║║║║ , for new screen, to return, 0 to clear CPU status ║╚═════════════════════════════════════════════════════════════════════════╝There are two columns of information (labelled #1 and #2) because there can be amaximum of two LINK modules for each PLC."LINK station number" is the unit number on the LINK module that is connected to thePLC.The "refresh" times is the highest, the lowest and the current refresh time of the LINKsystem. This is the time it takes for a change to go between the different PLC's.The areas to the right show the status of the other PLC's in the same link. The numberof PLC's on the link is shown in the lower right corner of each "matrix".7.8.5. Set PLC clock"Communication-Set PLC clock"It is used to read and set the PLC clock and calendar.┌────────────────────────────────────────┐│ Year : 1992 ││ Month : 2 ││ Day : 18 ││ Day of week (0 for Sunday) : 2 ││ Hour : 13 ││ Minute : 46 ││ Second : 50 │└────────────────────────────────────────┘Copyright Actron AB, 1992