Actsip-H - Esco-da.be

42 Ladder programming Actron ABThis command moves the last block comment of the current block forward to the nextblock. All subsequent comments are moved the same amount of lines forward.You may need to repeat the forward and backward move until all comments line upcorrectly.6.2.14. Moving comment backward ,,This command moves the first comment of the current block forward to the previousblock. All subsequent comments are moved the same amount of lines backwards.You may need to repeat the forward and backward move until all comments line upcorrectly.6.3. On-line, monitor and debugActsip can be either in Off-line or On-line mode. The current mode is indicated on thestatus line. When Actsip is started it is in Off-line mode. If the computer is connectedto a PLC system you can then set Actsip in On-line mode.Whenever Actsip changes from Off-line to On-line mode a window is shown that asksyou to transfer the PLC project to or from the PLC . The PLC is the temporarilystopped and the project is transferred. If everything is OK the status line will now say"On-line".When Actsip is in On-line mode all changes done in the PC is automaticallytransferred to the PLC system.When you are in On-line mode you may start and stop the PLC system. This isindicated on the status line as "Running" or "Stopped"If you enter "Monitor" mode the status of the PLC is shown in the ladder diagram.If "Monitor" mode is requested when Actsip is Off-line mode, On-line and Running isautomatically selected.With the "Communication-Monitor IO" command you can monitor any IO addressesof the PLC system. This monitor can give a good overview of the total PLC status.NOTE !When a changed block is transferred On-line to the PLC, the CPU ishalted a short while (4 seconds for the old type of CPU, 1 second on newCPU2).Copyright Actron AB, 1992