Actsip-H - Esco-da.be

38 Ladder programming Actron AB6.2.2. Drawing6.2.2.1. Redraw screen All changes done to the ladder screen since the last or operation will beundone and the screen will be redrawn by pressing .6.2.2.2. Move To move the cursor press the .If pressing the produces a line or clears a part toggle the mode intoMOVE by pressing one or more times and then press .6.2.2.3. DRAW/CLEAR/MOVE mode or Press the or key to toggle between the different modesDRAW/CLEAR or DRAW/CLEAR/MOVE if the "Setup-PC-Shiftable arrow keys"option is set to NO.6.2.2.4. Draw lines +If necessary, toggle the mode into DRAW by pressing or one or moretimes. Then hold down the key and press one of the . (It is notpossible to clear the left and right margin.)If the "Setup-PC-Shiftable arrow keys" option is set to NO use only the to draw lines.6.2.2.5. Erase lines +If necessary toggle the mode into CLEAR by pressing or one or moretimes. Then hold down the key and press one of the . (It is notpossible to clear the left and right margin.)If the "Setup-PC-Shiftable arrow keys" option is set to NO use only the to erase lines.6.2.2.6. Input Contact or +Position the cursor at the left end of the contact and press or +to get a contact or an inverted contact. A window will open, asking you for the address.You can now either enter a numerical address or a short comment. If this shortcomment is in use Actsip-H will write the short comment broken into two 5 characterparts above the contact and the numerical address below. The short comment willnormally be printed with as many characters as possible on the first line, if you want itto be as close to the contact as possible see the "Setup-Ladder programming" menu.Copyright Actron AB, 1992