Actsip-H - Esco-da.be

28 Ladder programming Actron AB╔═══════════════════════════ Automatic allocation ════════════════════════╗║NEW║║M33 DX DY DL DM DR ║║ WX WY WL WM WR TC ║║ X Y L M R DIF DFN MCS MCR TD SS WDT MS TMR CU RCU CTU CTD CT CL║╚═════════════════════════════════════════════════════════════════════════╝and the address M0033 by typing 33 and pressing .Move to the first line in the block and press to replace the old block.││CONTA NEW START ENGIN│CTE├──┤ ├────┤ ├────┤ ├─┬─────────────────────────────────────────────────( )─│X00001 M0033 X00000│Y00100│││ENDEND P ││OINT │├──┤ ├───────────┤ ├─┘│X00003 X00004│6.1.7. Checking the syntax.Is the project correct? Select the "Program-Syntax Check" command.System Program Allocation Printout Files Communication Setup┌────────────────────┐│Ladder││Instruction││Other module/program││Syntax check ││Info about project ││Delete block(s) ││New project│└────────────────────┘The window that is shown tells us that the program is OK.Your first PLC program is ready!6.1.8. Looking at the instruction code.╔══════════════ Syntax check ════════════╗║No errors detected║║║║║║Press ║╚════════════════════════════════════════╝In Actsip the ladder blocks entered are stored in the form of the instruction that buildladder blocks. For every output signal there is a corresponding circuit. So the examplewe have created so far will be stored in two circuits.Copyright Actron AB, 1992