Actsip-H - Esco-da.be

Actron AB Ladder programming 27│STARTENGIN│E├──┤ ├────────────────────────────────────────────────────────────────( )─│X00000Y00100││CONTA STARTENGIN│CTE├──┤ ├────┤ ├─┬───────────────────────────────────────────────────────( )─│X00001 X00000│Y00100│││END END P ││ OINT │├──┤ ├────┤ ├─┘│X00003 X00004│To make the changes take effect put the cursor on the first line of this block and press to replace the old block with the new modified block. Note that the highlightedleft margin is removed when you press . The highlight is used to mark thechanged areas of the project. If you should at any time do an unwanted change you mayundo it by pressing any time before you press or .6.1.6. Horizontal expansionWe have created a small project with two blocks. When looking upon the second blockwe note that there should be a contact in the first row between the "X0001" and"X0000".Move the cursor between the two blocks and press to open the menu.Mark Search Hor-exp Ver-exp Goto + comm - comm Erase commThe menu that opens on the last line of screen is called the menu. The cursor inthe ladder diagram is replaced with a solid block to show our position. The commandwe want is the horizontal expansion command "Hor-exp". There is two different waysto select from the menu. The first one is to use the to move to theselection and press . A quicker way is to press the first key of the command, inthis case the letter . Press and note that the screen is expanded horizontallyto make room for a new column.│CONTA START ENGIN│CTE├──┤ ├───────────┤ ├─┬─────────────────────────────────────────────────( )─│X00001 X00000│ Y00100│││ENDEND P ││OINT │├──┤ ├───────────┤ ├─┘│X00003 X00004Now use the to move to right side of the "X00001" contact.Press to add a new contact and give the short comment "New"Copyright Actron AB, 1992