Actsip-H - Esco-da.be

26 Ladder programming Actron ABThe left column shows the address (X00000, X00001, X00002, ..., X0000F), thesecond column will contain the short comments already defined. The third columncontains the long comments (it is blank). Use the to move to the linewith the address X00001. Enter the new short comment by typing "CONTACT".Press to accept the new short comment. The cursor moves to the next column.Type in the long comment. "START CONTACT FOR TRANSPORTER" and end itwith . Move the cursor with the to the address X00003 andenter the short comment "END". When you have pressed move down to thenext line by pressing . You should be on address X00004. Enter the shortcomment "END POINT" end it by .┌─────────────────────── Allocation ──────────────────────┐│ X00000 START ││ X00001 CONTACT START CONTACT FOR TRANSPORTER ││ X00002││ X00003 END ││ X00004 END POINT ││ X00005││ X00006││ X00007││ X00008││ X00009││ X00010││ X00011││ X00012││ X00013││ X00014││ X00015│└─────────────────────────────────────────────────────────┘By pressing the key the cursor moves 16 (10 hex) addresses down the list.Now press to leave the window. Press once more to leave the addresswindow. You should now be back in the ladder window. The ladder diagram isupdated to show the changed short comments and should now look like:│STARTENGIN│E├──┤ ├────────────────────────────────────────────────────────────────( )─│X00000Y00100││CONTA STARTENGIN│CTE├──┤ ├────┤ ├─┬───────────────────────────────────────────────────────( )─│X00001 X00000│Y00100│││END│││├──┤ ├────────┘│X00003│6.1.5. Changing an existing block.We are now going to change an existing block. Place the cursor after the contact"END" and press . Enter the short comment "END POINT". The contact shouldshow the short comment and the address X00004.Copyright Actron AB, 1992