Actsip-H - Esco-da.be

Actron AB Ladder programming 23│STARTENGIN│E├─┤ ├─────────────────────────────────────────────────────────────────( )─│X00000Y00100││-│├─┤/├─│X00001│Note that the contact automatically got the short comment "-". This is done to keeptrack of used short comments.Then press and enter the short comment "START" and note that the addressX0000 is shown below the contact. Press and enter the address Y0 (use the sameaddress as for the previous output) and note that the short comment is placed above thecontact.│STARTENGIN│E├─┤ ├─────────────────────────────────────────────────────────────────( )─│X00000Y00100││- START ENGIN│E├─┤/├────┤ ├─────( )─│X00001 X00000 Y00100││Press to move to the left end of the output. Now hold down the key and press the to draw a vertical line. If everything worked OK (seepicture below), continue reading on page 24.│STARTENGIN│E├─┤ ├─────────────────────────────────────────────────────────────────( )─│X00000Y00100││- START ENGIN│E├─┤/├───┤ ├──┬──( )─│X00001 X00000│ Y00100││││││││If your cursor moves but you don't get a line, don't despair. Thismight be because you have a slightly different keyboard.Test to see what happens when you press the or key. If you canproduce "DRAW", "CLEAR" and "MOVE on the status line, an option has been set onyour Actsip-H that makes the use of the key unnecessary.Copyright Actron AB, 1992