Actsip-H - Esco-da.be

12 Getting started Actron ABTo leave Actsip-H use the key to open the main Actsip-H menu. (When youwant to run another program on your computer.)╔═══════════════════════════════════════════════════════════════════╗║ System Program Allocation Printout Files Communication Setup║║ ┌──────────────────┐║║ │DOS command │ ║║ │Exit from Actsip-H│║║ │About Actsip-H │ ║║ └──────────────────┘║║║║║When you pressed a line at the top of the screen is shown. The words there eachrepresent a list of actions (things to do). The actions for each word is called a menu.The window shown is the "System" menu and it contains the command we are lookingfor the "Exit from Actsip-H" command.If you see a different menu use the to move to the"System" menu. (the leftmost menu shown above) If nothing happens when you pressthe try pressing the key and try the arrows again.When your screen looks like the illustration above press the until theselection "Exit from Actsip-H" is indicated by highlight or reversed colours.╔═══════════════════════════════════════════════════════════════════╗║ System Program Allocation Printout Files Communication Setup║║ ┌──────────────────┐║║ │DOS command │ ║║ │Exit from Actsip-H│║║ │About Actsip-H │ ║║ └──────────────────┘║║║║║Now press and you should be back at the DOS prompt.If you get a question about saving the project this is because you have made changesand Actsip-H wants you to decide what to do with them. If you answer "Y" you willthen be able to enter the project name under which the PLC program is to be saved.(This is the normal option.) If you answer "N" all the changes you have made to thePLC program will be LOST! (Use this only if you are sure that the changes areincorrect.) If you instead of answering "Y" or "N" press the key you willcontinue to program (use this if you inadvertently selected the "System-Exit" option).In the manual we will tell you to do the "System-Exit from Actsip-H" (or anothercommand). Just remember that the first part is the name of the menu that appear on thetopmost line of the computer screen when you have pressed and the next (andmaybe following parts) is sub-menus from this menu. E.g. press move the firstpart (before the '-') then select the correct line indicated by the second part the press if there is a third or even fourth part just select from the windows shown andpress . If you at any time want to get back to previous menu press the key.(+ will also end your Actsip-H session at any time without saving thecurrent project you are working on!)Copyright Actron AB, 1992