Actsip-H - Esco-da.be

114 Appendix Actron ABA: See page 96 for information on how to set the printer.Q: Sometimes when I try to enter an address during programming, the Actsip-Hprogram refuses to accept my address input but keeps erasing the input line allthe time?A: The address is not allowed for some reason. Please check the following:If external I/O X,Y, is there a module assigned to the correct slot?Is the address within the range of the slot?Is the address within the range of the memory cassette mounted?Can the address be used in the context (X123 not allowed as output, wordaddress where bit address is expected etc.)?Q: When I try to select address type X or Y for a short comment I just entered, theActsip-H only beeps and shows an '*' in the address field in the automaticallocation window?A: The symbol '*' is used to indicate that the address type is not available due tomissing modules etc. Please check the I/O assignment. Info in the manual onpage 93.Q: Sometimes when I try to move the cursor in the automatic assignment windowit is impossible to select some address types?A: The Actsip-H allows only addresses that are allowed in the context in question,please check the operation You are editing.Q: I just started making some printouts but suddenly all my short comments arelost and all I get is numerical addresses like X123 etc. in my listings?A: You have probably toggled the Short/Numeric display mode to Numericdisplay. Just toggle back to Short display mode (F5 key).Q: I have noticed that my hard disk have a tendency to vibrate more and more andfor longer time each time I load my Actsip-H project. Is this normal?A: The Actsip-H uses a lot of computer memory as a buffer for disk data duringprogramming. This will make the load time longer but the program will workfaster after the project is loaded.Load times can sometimes be improved by using a disk organisation programlike Speed Disk.Q: I renamed my project and now I have error messages when I try to load it.A: Please check that all three files (extensions .HBC, .HPG and .HSC) wererenamed.Q: I transferred my project to the PLC OK but when I tried to read it back all shortcomments and block comments were gone?Copyright Actron AB, 1992